How to remove a door dent from a Tesla Model Y | specialist PDR dent removal tools |

Рет қаралды 6,847

Dent Detail PDR

Күн бұрын

Пікірлер: 22

@alexandruszilagyi1176 10 ай бұрын

Awesome technician 👌

@dentdetailpdr 10 ай бұрын

Thank you kind words, thank you for watching

@tjm1015 10 ай бұрын

Nice Graham 👌

@dentdetailpdr 10 ай бұрын

Thank you for watching

@EugeneLambert 10 ай бұрын

Wow. Impressive!

@dentdetailpdr 10 ай бұрын

Thanks for watching Eugene, much appreciated!

@gemmaherdman9881 10 ай бұрын

Very good

@dentdetailpdr 10 ай бұрын

Thank you for watching

@craigf5536 10 ай бұрын

Excellent work buddy. When you're using a hard tipped tool to remove the dent does is not mark the inside of the door? I know manufacturers normally coat the inside of the door with cavity wax as it gets wet from rain water and washing. Just thinking about the possibility of future corrosion from the inside-out?

@dentdetailpdr 10 ай бұрын

Thanks for watching Craig. Some very sharp tipped tools can mark the inside of the panel, but not in this case. E coat or etch primer can be applied if this does happen, but it’s very unlikely that it does if repaired properly. You’ll be surprised how many new cars don’t have cavity wax on the whole of the inside of the panels, it’s only common in older cars

@craigf5536 10 ай бұрын

That's good to know. How much does a little dent like that normally cost to remove?@@dentdetailpdr

@dentdetailpdr 10 ай бұрын

@@craigf5536 no problem. Depending on the location on the bodyline and the severity of the dent it can range from £145-£245+vat, sometimes we have to remove the door card as not all are accessible through the locking latch

@bigsun8451 8 ай бұрын

Nice job, I have the similar dent over there. Is there a reinforcement structure beam near the dent?

@dentdetailpdr 8 ай бұрын

Hi thanks for watching. It will depend where your dent is exactly, an inner beam runs all the way across the bodyline in side there, so yes, if your dent is where the one on the video is, there is a beam you have to navigate round

@colinhamer6506 9 ай бұрын

Do you teach pdr at your shop or possibly come to us

@dentdetailpdr 9 ай бұрын

Hi Colin where are you based?

@GreatIrreligious 10 ай бұрын

I'm wondering how much was this work?

@dentdetailpdr 10 ай бұрын

Hi thanks for watching and for the question, dents like this are around £195-£245+vat GBP depending on the severity of the dent

@lazlaz4428 9 ай бұрын

Temperature ?

@dentdetailpdr 9 ай бұрын

Hi, we get the panel temperature on aluminium panels at 29 degrees to work it, this is the same for glue pulling and pushing. Compared to steel panels at around 21 degrees