How to replace Yamaha warrior 350 stator

In this episode we show you how to remove and install a new stator with a few tips and tricks while doing so. Be sure to use the correct size Phillips bits as the screw heads are prone to stripping out.
zoomzoomparts....
zoomzoomparts....
moxcracing.com/
/ zoomzoomparts
www.instagram....
YAMAHA WARRIOR 350 BUILD SERIES
• 1998 Yamaha Warrior 35...
YAMAHA WARRIOR HOW TO VIDEOS
• How to video's
TEST AND TUNE DAYS
• Test & Tune Days
CHECK OUT OUR MERCH
zoomzoomparts....
PRODUCT LINKS
zoomzoomparts....
zoomzoomparts....
zoomzoomparts....
POWERSPORTS INSURANCE
www.powersport...

[@joeychapman4768]

At 6:47 it says line up the pickup mark but that's not where it was stock

[@monrover48]

Came here to see the inside. Mine had rust and mud

[@calvinfouts4887]

34 seconds in (idk the terminology) you use the screwdriver to pop it out mine will only come out about a quarter inch idk if I’m doing something wrong I’m replacing a gasket but I’m struggling cause I’m new to motors

[@zoomzoompartsllc]

that is the Boss fitting you may have rust inside of it or even dirt jamming it up i would use the open end of a wrench if you can get on it to pop it out the rest of the way just come at it from a few different sides kind of work it back and forth. once you get it out inspect it clean both boss fitting and crank then when putting back together use antisense

[@omaro8869]

Should I use Loctite?

[@SuzukiMarauder2004]

Yeah that's not the way my stator ligns up, and I also noticed his case doesn't have a slot were the bearing and seals are in the case. Totally different

[@joeychapman4768]

My stock stator the two pick ups lined up together at the top why does this video say to line it up with the bottom of the case

[@zoomzoompartsllc]

there was a few years that had duel pickups the stator has changes about 5 times from 87-2004

[@adabwilldoya92]

Is the big bolt in the center reverse thread or is mine just stuck

[@adabwilldoya92]

I went to the end of the video and it looks like you tightened it in by hand like normal I'm going to try a pneumatic gun next time

[@woodken]

What size were the upgraded bolts you held the stator with ? Thanks

[@zoomzoompartsllc]

They are the same size just a stronger grade and different head (not a fan of the Japanese standard)

[@woodken]

@@zoomzoompartsllc checked zoomzoom website couldn’t find it !! Do u have the link to it ? Thanks

[@zoomzoompartsllc]

For some reason youtube is not telling us when people reply we may have the bolts just not on website give us a call and we can help you

[@expert_gaming9179]

I popped mine opened and it did not have a pin