How To: Set Iron Ferrules

[@crackspider101]

Made it look an absolute doddle. Nice work 👍

[@bradgilbertson6795]

Simple and straightforward. Thank you!

[@BourneAccident]

Perfect. Not that everyone has to do this, but I set the spine to the target 9:00. Helps keep the club droop consistent from club to club.

[@timdinh6349]

Great tips, thanks Ryan

[@garyyip8854]

Hi Ryan, all your builds are perfect with regards to shaft tip & hosel diameter - never seen you have a club that didn't 'sit' after insertion. Tour issue stuff? (laughing emoji)

[@nicholasmarshburn3041]

Nice video. Thanks.

[@ethandevore1799]

Hey Ryan, great vid. Quick question for you, is spine alignment and flo necessary when building a set of irons?

[@shellyad100]

Great vid thanks. .can I use metel ferrules for graphite iron shafts. Thanks Regards David

[@DavidL-u4g]

Happy you get to the 👉 Some of the other guys go on & on.. they bore me 😂

[@chutiyasuthiwan9715]

hey Ryan, great vid, what epoxy do you use, it looks mean.

[@saturnin5970]

Hey there man, I have a tour AD driving iron shaft and I’m attempting to put a PxG driving iron head on. There is a little bit of wiggle room as the PxG head seems to be wider than the perfect fit. What would you suggest I do to make sure there is no breakage?

[@ryanbarath1916]

Best solution with many PXG heads is to use a small shim to insure a tight fit

[@sirciderchops4049]

Excellent

[@ncgc]

Great content

[@firstname7330]

I thought more epoxy was required? When I took apart my Hogan Apex Plus's (circa 2000) the other day, the "glue stick" left in the shaft must have been 1/2" to 1" deep into the shaft.

[@matthewshanholtzer9571]

what kind of epoxy do you use for the iron? Thanks!

[@CraigalFun]

Swingweight when doing this?

[@djmitch1]

boiling water is a great tip. thanks

[@coach7136]

Can I remove and refuse the shaft?