How to troubleshoot Turbochef oven F-3 Mag fault

[@MegaAK28]

dude you have literally helped me fix 3 Turbochef's with 4 different tips to look into and how to test without thinking its the freaking magnetron. Thanks a bunch man you rock

[@hollowman2777]

We just picked up Dunkin and I have never worked on one of these. I’m so glad I found this video.

[@smartguyrepairs1500]

4000 volts dc in those capacitors aint no joke im glad you said discharge them

[@SkyCandyVisuals]

Great explanation of the process of elimination. I would troubleshoot these the same exact same way.

[@silentobserver975]

Thanks for sharing your knowledge. Appreciate the recommendation to change every component in the circuit.

[@diprana6372]

Can you make some more video on toasters and Frige, like that, please? You are great.

[@Yosh-doesnt-understand]

I've got an oven that is throwing an F3. Im getting 15.5 amps off the brown, and each mag is giving between 7.2 to 7.8 amps. Where do you go from there?

[@swervomatic]

Those are normal readings, so I would check the connector on the brown wire that goes thru that ring sensor on the board. If that's OK, then you more than likely have a bad control board because it shouldn't be giving you an f3 fault with those readings.

[@diprana6372]

Thanks for video 🎉

[@Keorvane]

So, if you have low amperage, would you continue to replace the circuit or just the magnetron? Also does this unit have relays to check on or is it just the fuse? Thanks!

[@swervomatic]

There is Ice cube relays mounted on the back wall. If it's a low amperage you can try just doing the mag. I recommend doing the mag, cap, and diode tho

[@youtubeyouthpastor]

Thank you so much for posting this - I think we've fixed it, but our Magnetron wasn't delivered. I'm wondering - if we use it for a period of time (between now and when we can get the magnetron here), and then a few weeks later it throws that code again because the Magnetron was a part of the problem, will it damage all the other new parts we put in? Or should we just not use it at all until the magnetron can arrive? Thanks!

[@swervomatic]

Depends on what parts you replaced so far. If you just did a burnt up transformer, I would wait for the mag.

[@РинокРибалки]

Appreciate you for the video it is so helpful!! Please tell me where I can order parts for this model?

[@donnellbaxter8050]

Thanks make more videos

[@estqwerty]

good job!

[@AO-nd9mr]

where are you located? To request your service?

[@swervomatic]

Baltimore, MD

[@AO-nd9mr]

@@swervomatic Do you service around the DMV area? I am located in Fairfax, Virginia.

[@swervomatic]

@@AO-nd9mr yes. Look up Watsons Rapid Repair on Google