HYBRID BRAKES AIR BLEEDING ACTUATOR REMOVED : 2007 TOYOTA PRIUS PART 2

[@tanzaniacarschannel6975]

This car was ahead of its time when it came to its existence.

[@tylertran93nsx]

What scanner do you recommend? i have a 2012 Prius getting ready to replace ABS mdule and brake booster.

[@besikbesik2390]

Hello, may I have a question, I have damaged the abs on a 2009 Toyota Camry hybrid, can it be repaired, or what part of the unit is being replaced, what car is it suitable for too?

[@luizcamey4818]

Did you have to perform a valve calibration as well?

[@SkillCollectors]

In my experience, I've never had to do anything outside of what the scan tool guides me through.

[@Chris-go9ti]

The front brake bleeding. One step says remove the hose and fluid shoots out. What does your texh do on that step? Towels to block it?

[@miguelclarke3523]

I'm hearing constant beeping sound anytime I put my 2007 Toyota prius in drive or reverse what could cause that?

[@Chris-go9ti]

What anout what about the next step. Linear valve reset? Does your scan tool not have that?

[@saifeetech707]

Boss the both relays are not connecte during the bleeding procedure ?

[@jonbennett7815]

Is this also called the brake actuator?

[@SkillCollectors]

Yeah, same thing.

[@Chris-go9ti]

I forgot to ask can you vacuum bleed the front brakes and the back?

[@waqarqadeer5217]

Hi, Were parking brakes pressed in throughout this process?

[@Chris-go9ti]

First step says apply parking brake

[@phr33kttv]

Just did the same job on my 2006 Prius, trying to bleed the actuator with techstream on a laptop. Everything is connected properly and it picks up the vehicle but techstream will not start the bleed process, just keeps saying "Bleeding Failed, try previous instructions, would you like to try again?" and just can't get past that. ANY help would be appreciated so much! Good video. Thanks!

[@SkillCollectors]

Unfortunately I’ve actually never used techstream to do this job. If you got the connector on the actuator properly seated then I’m not really sure. I have never run into any connection issues with the snap on scan tool or the Autel scan tool that I have. It’s normally a pretty straight forward job just following the instructions. Anyway you could perhaps borrow or rent one of those tools? Or perhaps a Toyota dealer tech can chime in.

[@Branman1583]

I just had the same problem on an autel. When it tells you to remove the relays, dont do it yet. Keep hitting next until the process has started. Then remove the relays.

[@nashmetro8529]

"bleeding failed, try again". Yes. I bought and returned a hand held unit last year that said it did ABS bleeding. That specific step kept coming up, so I gave up & returned it!

[@Koala_z06]

Hey man what scanners do you recommend

[@SkillCollectors]

Autel makes some good, affordable scanners.

[@Koala_z06]

@@SkillCollectors can the autels complete the service you just did

[@SkillCollectors]

@@Koala_z06 Pretty sure most of the tablet style ones can. The one I have can, I have an IM608 which I use for locksmith work but also does scan tool stuff.

[@tomjohnson-y6e]

so u did this after the brake actuator was replaced not while it is removed? i just want to double check?

[@SkillCollectors]

Yup, after it was replaced.