Installing a Brabantia Rotary Clothes Line using a concrete tube

Installation of a Brabantia Rotary Clothes Line using Brabantia's concrete tube.
The instructions for the tube state a 350mm deep hole, but the tube itself is only 180mm high. I 3D printed an adaptor so I could support the tube on a copper pipe whilst the postfix went off. Worked pretty well.

[@paulmorris6596]

Great job. Do you have the STLs for the 3d printed adapter?

[@GeeWhizRS]

Sure thing, just uploaded it. I recall I needed to slightly file out the inner 15mm diameter a tiny bit to ease the copper pipe in. Hope it works out for you. www.thingiverse.com/thing:5358306