Installing an Oil pressure gauge on my Twin Cam Harley Davidson

[@ElLoneWolf93]

I added a Russell braided oil pressure line instead of the black hose. I think it looks good and seems sturdier.

[@decaf8660]

Now that you have an oil pressure gauge, what are your psi readings cold & hot, idle & cruise with the Twin Power oil pump? Thanks for sharing.

[@fritzk9118]

👍👍👍👍👍👍👍

[@Britcheflee]

Could you provide link or name of the oil pressure gauge and the connector at the block please? I want to install one just like this with the original electrical pressure sensor still there in addition to the mechanical gauge. Thank you and a nice clean job.

[@GilstrapGarage]

www.ebay.com/itm/391725879872?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=ZP2EXHqvTmC&sssrc=2349624&ssuid=wV0poAigRuy&var=&widget_ver=artemis&media=COPY

[@bobnolen7611]

I’m not sure about the plastic line. Braided stainless steel would be my choice.

[@SuperRobertheath]

Cool. I’m ready for you to fire that bad boy up and hear it!

[@GilstrapGarage]

Me too 😔 it’s so close!

[@jackma9516]

Hey man question. What’s a good way to check if I have an exhaust leak on my dyna. I installed new gasket and flange on my front head, tightened it to spec but I have a feeling there might be a leak. I haven’t found a good video on KZbin to explain.

[@GilstrapGarage]

i get a small piece of paper, like a post it note or something similar, and move it around where you think you might have a leak. if it flaps it leaking lol. you can also spray soapy water on it when its still cold and see if it bubbles. don't run it too long though or you'll burn that soap

[@dynasore2993]

Hey man, have you considered an external breather mod and video?

[@GilstrapGarage]

Not yet! It’s one id like to do soon though.

[@paulbuckberry7683]

I bet you swap that plastic pipe out for a nice braided hose before the seasons out.

[@GilstrapGarage]

I bet you’re right 🤣

[@ericrhinehart6055]

@@GilstrapGarage Yep, not if it will fail, just when! AMHIK

[@АндрейНескажу-щ9к]

Can you please tell me what part number of loctite thread sealant you use?

[@michaelescobar3134]

LMAO 😂

[@aussie1546]

I am not fan of oil pressure gauge. It tells you if your engine is done. Without that gauge there is a simmer of hope LOL

[@garryhorton9105]

I know what your saying 😅

[@GilstrapGarage]

🤣🤣🤣 true!

[@JohnJones-op8uf]

Dude, the rubber glove… bad idea! Absolutely no protection for the fitting… also, there is a socket made for that pressure fitting… just sayin…. Do appreciate the vids.

[@robertsmall6076]

🇺🇸🤙