Jeep Grand Cherokee 2005 - 2010 ABS code U1417 ESP BAS | Rear Wheel Bearing

Remember to please like and subscribe if you found this video useful. 😎👍
Watch me diagnose and repair similar ABS codes U140A C101F on a Jeep Wrangler.
• Jeep Wrangler ABS code...
Watch me diagnose and fix a separate issue this vehicle had. Blower motor only worked on high setting.
• Jeep Grand Cherokee 20...
Check out how to remove rear pads and rotors.
• Nissan Pathfinder 2005...

[@TheHortond]

I had the same problem. You fixed it the same way I would have. My e brake spun around and piled on one another and rested right on top of the sensor and tone ring. All the hardware was missing from the e brake side and the cable was snapped. I just left it all off and put it back on until I can fix it. I replaced all that I could with new sensor but the brakes dented and ruined the tone ring so now that needs replaced. Same wheel too. Now I have to do the same thing you are doing to fix it. Hopefully it goes as smooth.

[@victorr2710]

I have faith you'll get it done correctly

[@d.l.horton4254]

@@victorr2710 I replaced both hubs for both sides. Now it leaks a little on the passenger side. I think I was tired when I got to it. So I might have missed something. But it runs fine now. If you have a scanner you can watch the signals coming from all 4 speed sensors while driving and from each wheel. The signal for the bad wheel will drop off if its bad and will turn on the ABS light. But you can see not working then when fixed you can see working. Its a great time.

[@stewatparkpark2933]

Looks like you left the o ring oil seal off the back of the hub .

[@victorr2710]

Looks can be deceiving

[@germanayala4192]

I did this on my 2010 jeep gc srt8 and now my hand brake is loose and parking brake isn’t working any idea why

[@AaliMr007]

I have one question, I got the error code C1011 left front wheel sensor the issue is when I am driving over 20 between 20 and 40 my wheels seems to get locking or braking the tires

[@victorr2710]

Take it to a shop immediately

[@latrishaoliver]

So if all my lights are on where do I go to get the problem fixed my lights came on Tuesday and stayed on today

[@victorr2710]

go to a place where people fix cars and pay them to fix your car.

[@Moosenukkels]

@@victorr2710 Having this issue with my commander, have any idea abt how much this will run me?

[@thatmodshop7160]

​@@Moosenukkelsyou ever get it figured?

[@Moosenukkels]

​@thatmodshop7160 Yeah I got a good mechanic here who does all the stuff I don't have time for or don't feel like doing. Cost me about 100 bucks. Could have probably got a deal on doing them all at once, but I didn't. Should have. Now I've had another one go out, lights been on about 6 months, but I'm not in limp mode so I'll just drive it until it does go into limp mode lol. Jeep went insane with the electrical crap on this model.

[@dangerousfreedom4965]

Why not just replace the sensor?

[@victorr2710]

why not just replace the blinker fluid?