Jon Boat Bilge Pump Installation

This quick video shows how to install a 12 volt Bilge Pump in a flat bottom aluminum jon boat for less than $20. It sure beats bailing water with a jug! I later attached the PVC pipe to the stern wood with conduit clamps and a couple of screws. This is a standard improvement I make to all our flat bottom boats. I sourced the pump from our local Walmart.
🔴 Subscribe to our channel:
/ returningtobasics
Background music: She's Gone by artist The 126ers.
#flatbottomboat #bilgepump #fishing #hunting #returningtobasics #thevickersgroup #sustainability #preparedness #prepping
All Rights Reserved. Returning to Basics - The Vickers Group, LLC
Copyright 2021--2022

[@MySliceOfHeavenoutdoors]

Great job on that installation Neal. Its cold here, About 15 degrees right now. even colder tomorrow.

[@ReturningtoBasics]

We ended up having some temps below zero. Today it's almost 32!

[@teddymac3737]

How did you anchor the bilge pump to the bottom of your boat?

[@ReturningtoBasics]

I went back and installed a couple of conduit clamps to hold the pump in place. Thanks for the question and for watching Teddy.

[@kokoyhawaii]

Did you add a fuse between pump and battery?

[@ReturningtoBasics]

I didn’t on either of my boats.

[@johnhaynes2933]

Where did you buy the solar panel at

[@ReturningtoBasics]

eBay. I can't find them now. I wish I'd have bought 5 more.

[@tjackson4802]

Can you post a picture of the solar panel, please?