K Swap K11 Micra Custom Exhaust Manifold - Part 4

[@Oubergine990]

Your work is just phenomenal i absolutely love the jig design and how you show the whole process . Great stuff Gizzy

[@quattrolabs_3383]

Absolutely love the videos. I get so much good information about fabrication from you. Thank you for explaing the jigs in depth that was super helpful.

[@jimxiong04]

You make fabrication look easy! I know it's not!🎉🎉

[@andrewrigg4905]

Fantastic work, I love making jigs for this kinda thing too makes the job way easier

[@neddddy]

So much flange in one video ❤

[@gafrers]

Great work. Love the Jigs

[@gabrielratinho1869]

Nice work man, I was looking in your site and thinking if the poly engine mounts micra k11 will fit a nissan sunny N14 1.4l engine it seems to me be the same but im not sure. If you could figure it out I be gratefull.

[@GizFab]

Only way to know is if someone sent me a complete set of mounts. I can check.

[@btcc.s3]

Hi mate what linisher is that? Been looking for a decent size one for ages to finish off my manifolds after welding them up too

[@GizFab]

Axminster Single Phase

[@btcc.s3]

@@GizFab nice one cheers

[@Lexusturbo]

How do you fill the gap in the middle of the 4 legs in the collector?

[@GizFab]

Weld in a Star-Shaped piece from the inside before welding the collector on.

[@Lexusturbo]

@@GizFab excellent. That’s pretty much what I did with mine - just wanted to confirm it’s what the Pros did!

[@darrenlynch1772]

Dumb question mabey. How do you weld the center of the 4 pipes inside the collector

[@GizFab]

You weld the pipes internally first, then slip the collector on, weld around the outside.

[@darrenlynch1772]

​@GizFab ok I see. Thanks for reply. Unreal work as always man

[@rc4625]

@@GizFab was wondering this too, do you just make a little plate to fill the "hole" between the 4 pipes and weld it?

[@GizFab]

@@rc4625 Yes, you weld in a "star" shaped bit between the pipes. you then wrap the weld up between the separate pipes. Slip the collector over and weld all the way around.

[@Connorjohn2001]

What are you doing about the wiring to get it up and running

[@GizFab]

For this particular Car, Universal K-Swap Harness, Terminated into a Haltech Elite 1500 and IC-7 Dash. Keeping the OEM Rev Counter, speedo etc isnt a concern for this build.