Lee LoadMaster - Auto Disk Powder Feed Setup by HPFirearms

hpfirearms.blog...
/ usbrotherhood11b
hollowpointshoo...
Another video in the Lee LoadMaster Series. In this video I'll show you all the components of the Lee Auto Disk Powder Feed and how to install, adjust, and function check as you go.
Please show your support of Hollow Point Firearms by rating and subscribing! Thanks!
©2012 -- Bobby Hughes / Hollow Point Firearms. All videos are private property of Bobby Hughes and may not be copied, duplicated, or used without expressed written consent of Bobby Hughes.

[@CeremoniesMasterof]

Good video. Was lost trying to figure out how the autoloader worked. Thanks a lot, man.

[@donaldnorth3714]

Very awesome! Your video is the first one I've found that explains the powder measure and it's set up! Thanks a million!

[@daverose69]

Nice Video, Thinking about the Lee Loadmaster. I think I can get the primer system working better as I have a machine shop. Now I know how that powder measure works, its simple.....

[@MrDorsch213]

you are one of the most helpful re loaders thanks bro

[@JRFINK119]

Just got this press. Thank you for making the video. Helps tremendously!

[@taranislighting548]

Your video was very helpful!!!

[@TheSplinter99]

Hi, Nice set-up, Out standing videos. I am just starting out and with your knowledge maybe answer some questions. At present I own S/W M&P AR-15, A Ruger 45 SR, -1911, Berreta 9MM, 50 cal Black Powder. All of witch I want to reload 1) do you recomend a loadmaster or a pro 1000? 2) would you recomend Midway or River Ridge where I can buy the kit to include the shell funnel with those dies all set-up by them?? 3) If you were to do it again would you change anything at all???

[@realinohio]

Thanks! This was really helpful

[@tonyconnolly5512]

great vedio help me a lot with my new loudmaster press i just got

[@lavoydon]

Good job. I'm using the same set up for rifle, double disk. I a little concerned that I'm not getting the accuracy I want. I was aiming for 41.7 imr 4064 and only 4 of 10 hit the mark. I had from .3 under to .3 over. Any suggestions? Don

[@LCdonkeyshow]

I get powder between the slide plate. If I tighten the brass screws just a wee bit to tight, it's hard to cycle, if I just barely tighten the brass screws I get powder going everywhere.

[@tryandave]

Very Good Video! Thanks

[@TheSgtk9]

Could you make a vid for 223 or 308, using double disks and making loading solutions. Thanks

[@neilberi763]

Hi so if I buy a 223 loadmaster do I need to purchase a riffle charging die to add to my purchase. as I cant seem to get the original working as it seems to crimp not flare I'm confused

[@absolutionoffroad]

Great Video Mate!

[@austin3538]

good video

[@tdallan1941]

Thanks for your help very informative

[@tdallan1941]

Very helpful

[@Merkdog43]

explained perfectly.

[@peetymed]

thx for the info. im starting to load .40 s&w.

[@adamazouri9482]

Maaaaatt Daaaaaaamon

[@randyemenhiser2573]

"Expander dah"? Wtf is an expander dah?