Making a shed ramp

I built a shed ramp with Trex! Let me know what you think!
The best drill and driver:
amzn.to/37eo4f4
Materials:
(3) 2X8X8 ground contact treated lumber
(1) 8' Trex Square Edge
(3) 16' Trex Grooved Edge
Composite screws, deck screws and (5) 4" lag bolts
I had to make the shed ramp 5 feet wide and 4 feet long. The shed was about 1 foot off the ground. I dug down 6 inches to make sure it would be level with the ground. 1.5 inches for the pavers 3.5 inches for the 2X4 and 1 inch for the Trex boards. I made sure the bricks were level. I cut the boards to length and then ripped them in half to make the 2X4. I placed one end of the board on a cement block and the other end in the shed opening. I placed my level against the board and side of the opening to determine the angle that I needed. I cut all the boards at the same angle on the chop saw. I used decking screws to hold the frame together. I screwed one lag bolt into the middle of the ramp to attach it to the shed. I used my level to make sure it was level and used the rest of the lag bolts to secure it in place. Then the frame was complete. I decided to cut Trex for the sides of the ramp first as it was easy to scribe a line on the back to determine the correct angles. I did both sides the same way. Next I cut the square edge Trex for the two sides. I cut them at a 45 degree angle to meet up at the bottom. The last part was just to fill in the middle with the Grooved Trex. Let me know what questions you may have.
Thank you for watching!
All the songs in this video are by:
Markvard:
/ markvard
/ markvardmusic
creativecommon...
Music provided by RFM: • Video