I just added ozone this Black Friday. Wish I would have done it sooner. Like you mentioned I thought it was complicated and could cause health issues. Can't believe how simple and effective it really is. The water clarity is awesome!
@viking_reefing10 ай бұрын
Yeah man, it’s great! No idea why it not used more frequently
@umoraes200910 ай бұрын
Good to know you're getting great results with ozone .... Did you think about adding a air media filter between the air pump and ozone generator ? This will save your ozone generator for + 6 months
@viking_reefing10 ай бұрын
@@umoraes2009 not really as I see that adding more maintenance with drying out the media than cleaning the generator every now and again.
@IMGbaugher10 ай бұрын
Great video. My wife just got me an ozone generator and air dryer for Christmas. I’ll be hooking it up tomorrow. She got me a Poseidon 200.
@viking_reefing10 ай бұрын
That’s great. I’m sure you’ll be happy
@mikegalasso671810 ай бұрын
I added it to my reef in June and I absolutely love it!!! Gorgeous reef, btw.
@viking_reefing10 ай бұрын
Good man! It sure is great :)
@coralreef-arg10 ай бұрын
Ozone is super important!!! Great video!!!
@viking_reefing10 ай бұрын
It really is great!
@fishncorals13 күн бұрын
Brotha, carbon gives you that same effect. I been using for years now and it hasn’t been any different. Thanks for sharing.
@viking_reefing11 күн бұрын
I’ve used carbon for years and years and in my opinion it’s a lot more hassle and ozone is vastly superior in terms of water clarity in my opinion. Carbon is great but my use cases for it isn’t water clarity :)
@fishncorals11 күн бұрын
@@viking_reefing be careful using ozone.
@viking_reefing11 күн бұрын
@@fishncorals it’s actually fairly risk free…provided you don’t do something really stupid.
@queencityreefs10 ай бұрын
Great video. I have an ozone generator that I purchased almost a year ago. Need a few parts to make it work with my skimmer but there's a bit of intimidation playing part of the delay. Enjoyed watching 🙌💯✌️
@viking_reefing10 ай бұрын
Just get to it. It’s stupidly simple. Can’t really mess it up to bad :)
@federicomanglavite989710 ай бұрын
Great video! I have a question for you. You are not using an air dryer, which would prevent the formation of nitric acid. How do you clean the Certizon ozoniser, when nitric acid accumulates on the corona discharge cell?
@viking_reefing10 ай бұрын
I just remove the metal plate and wipe it down
@juanitocastilloysusmurgas710710 ай бұрын
Hello friend, great video, I have 30 years of experience with ozone, one question, what is the natural ORP of your system without ozone? And what ORP do you have configured? thank you
@viking_reefing10 ай бұрын
Thank buddy! My natural orp sits somewhere around 250ish. I have it pegged to 375 but since i have around 8.6 in ph it suppresses orp somewhat which makes it difficult to get it over 350
@flyinbryan715110 ай бұрын
Thanks for the video, great content! Glad I’m not the only with elevated ph.
@hussainferoz75410 ай бұрын
Hi. I just saw your video. I am from singapore. May I know what wave makers are you using? They look great with the left to right movements.
@viking_reefing10 ай бұрын
They are Nero 5’s mounted on OceanMotion engines:)
@hussainferoz7549 ай бұрын
@@viking_reefing thank you just love them😊
@forsongonly29099 ай бұрын
It's a great video that I plan to run ozone in my tank. Do you control your ozone generator through APEX?
@viking_reefing9 ай бұрын
Thanks! No, it’s controlled by my profilux ;) Same thing ehhe
@KillerKev196110 ай бұрын
Outstanding.
@viking_reefing10 ай бұрын
Glad to hear it!
@cesarjuarez20665 ай бұрын
Awesome video
@viking_reefing5 ай бұрын
Glad you enjoyed it
@berniemorris79979 ай бұрын
I see you are not using a dryer before your ozone. Any issues with moisture going in ozone generator?
@viking_reefing9 ай бұрын
Nope. I rather clean the ozone unit like every 4-6 months than constantly fiddle around with an air dryer hehe
@Loja_das_MacroalgasАй бұрын
Hello from Brazil! Can we use ozone with shrimp and other crustaceons?
@viking_reefingАй бұрын
Sure thing!
@Loja_das_MacroalgasАй бұрын
@@viking_reefing Thank you very much!
@caspermadsen106710 ай бұрын
How often do you clean your skimmer cup
@viking_reefing10 ай бұрын
I’d say about every two weeks
@forsongonly29098 күн бұрын
How many Mg/Hour do you set of the input? Also, do you run ozone only at night time? Thanks
@viking_reefing6 күн бұрын
It’s set to full blast. 200mg/h but it’s controlled by my Profilux based on the pro reading. It runs regardless of time if my pro drops below the set point.
@forsongonly29096 күн бұрын
@@viking_reefing I absolutely agree with you! I face the same problem as you. My ozone machine is switched on and off by Apex. My ORP has never been able to increase to target (380-400). Because the ORP will decrease every time you change the water, and it will take time to increase. I found that the ORP of my fish tank did not increase from 3am to 8pm, even though I had opened it at 200Mg/H. Also I found that when I run ozone it has a negative impact on my skimmer operation (BRS also mentioned this). So now I will only run ozone from 8pm-3am. I'm looking for a way around it. Anyway, thank you 's reply.
@viking_reefing5 күн бұрын
@@forsongonly2909 huh. My orp stays relatively steady at 370-390. That’s with automatic water changes throughout the day. I also don’t see any effect on the skimmer…perhaps it might be improved somewhat. However, I do see major differences in baseline orp if you keep detritus out of the tank or not. If I slack on removal the ozone generator has to work a lot more.
@NiggoS10 ай бұрын
How you measure your orp? Is it necessary?
@viking_reefing10 ай бұрын
With my profilux. Yes, if you are running ozone.
@Kas_Reef10 ай бұрын
What are those powerheads on that rotates? They look like Neros.
@viking_reefing10 ай бұрын
They are Nero 5’s mounted on OceanMotions :)
@po2lony1237 ай бұрын
Where can I buy it in US so it has 110V plug?
@viking_reefing7 ай бұрын
I don’t think they make them for the us market. However, ozotechs posidon generators are great and from the us
@ikanMarine10 ай бұрын
my tank 10feet with coral..only 2 big skimmer and.. i use the cheapest way.. that is filter floss ..no socks.. settle..😊
@viking_reefing10 ай бұрын
You should try ozone. You will be amazed with the results. Floss and mechanical filtration will not remove the yellowing of the water that happens over time :)
@Loja_das_Macroalgas2 ай бұрын
👏🏻👏🏻👏🏻👏🏻
@nandakumarsubash10 ай бұрын
What is the minimum tank size required for a salt water tank and which fish I can keep? Please note that Coral is not allowed in my country and I am new to the salt water tank.
@viking_reefing10 ай бұрын
You could keep some small gobies in a 30L
@nandakumarsubash10 ай бұрын
@@viking_reefingthank you. What is the recommended size for a single or a pair of Nemo.
@viking_reefing10 ай бұрын
@@nandakumarsubash 50L perhaps
@AndrewDeSerio10 ай бұрын
How many hours a day do you run it and at how many mg. I have a 240 give or take gallon system I have a Poseidon 200 I’m running 88 mg an hour about four hours a day trying to figure out what is best for my tank.
@viking_reefing9 ай бұрын
No idea really. It’s completely controlled by my ghl profilux. Just set a decided orp point and forget about it
@AndrewDeSerio9 ай бұрын
Do you run for hours on end or set it to constant? I’m nervous to run more than 4-5 hours
@viking_reefing9 ай бұрын
@@AndrewDeSerio no idea. As I said it’s completely controlled by my profilux. It runs as soon as the orp drops below the hysteresis of the programmed set point. Why would you be nervous?
@AndrewDeSerio9 ай бұрын
@@viking_reefing I don’t want to over sterilize. What’s your tanks natural orp mine only sits around 230
@josebernal778910 ай бұрын
Hi where can I buy the carbon cups TIA
@viking_reefing10 ай бұрын
They are from royal exclusive
@javierlopezrecondo574710 ай бұрын
Hola, más vídeos del nyos opus, thanks
@viking_reefing10 ай бұрын
Will do ;)
@RustyCommunity9 ай бұрын
Do you think I could put a Achilles tang in a 50 gallon or no I’m trying to find a cool tang and that’s the only one I’ve came across I like
@Maximo21akuma10 ай бұрын
Does not seem worth it. Playing with fire if you ask me.