Pelpro - Service Video - Auger Cycle Light Flashing

[@darrellhill7483]

Without a doubt your video is the best exhaust motor on my 2012, hh120 Pelpro failed on Dec.23rd, 2020 I took the blower to my electrician on the 27th he replaced the bearings I picked the unite up on Jan. 17, 2021On the 20th I spent the day cleaning the stove I found that mice had gotten into the stove and eaten through 3 wires I repaired them then closed the stove. I plugged the stove. the auger cycle was flashing. After days and hours of calling and which videos at 9am this morning January 26, I found your video after following you step by step it turns out the hopper safety switch is bad I installed a toggle switch temporarily, I ordered a new switch (coming soon) My Pelpro us running fine thank you.

[@stanray9283]

So the possibility of the auger motor being jammed up with sawdust from the pellets is not a problem???when the auger motor sounds extremely loud and both lights are flashing that has always been the fix on my pelpro 120. Pull the pellets out of hopper and unscrew the four bolts on the auger housing and clean out the sawdust

[@ktm513513]

My combustion motor doesn't work, what two wires go to the switch above the motor?can I get a wiring diegram?

[@jeremyfertig4187]

Thank you...very helpful!

[@ripken069]

good video, but if you have to call the number don't waste your time. The lady I talked to hasn't seen this video, and is very conflicting