Pilot RC Slick build update 3

This should be the final update to this build before it is complete.
To clarify, the white coffee stirrers that I mention in the video are for keeping the antennas in place and straight while I am flying.

[@radukapu]

Looking very good. 👍🏻I think you have the elevator servo other way around. The spline should be closer to the horn on the elevator not away. That’s why the rod was short.

[@ghostriderrc]

I considered turning the servo around, but the wire would be pointing toward the rudder. It made the servo wire turn too tight for my liking.

[@robertnet4150]

Great videos what type of epoxy do you use for the hinges

[@ghostriderrc]

I use BSI 30 min epoxy. Any two part epoxy should work well. The 30 min gives you enough time to get everything in place before it starts setting up.

[@stephenmclean5715]

Partie 3

[@julianmuller41]

Did you by any chance weigh the aircraft without any electronics (without motor, battery, esc, servos etc.)? And whats the flight ready weight of your setup? Greetings from Germany!

[@robertvey1560]

Hello Germany. I did not get a weight of just the airframe. My take off weight is around 9lbs 5oz (4.224 kg).