In this video, I install and plumb a MAC 4-port boost solenoid for the turbo LS setup. Another day, another bracket - this is the way of the project car.
Пікірлер: 15
@JB-by1zl Жыл бұрын
Dope YT name bro, got a sub off of that. Gonna go watch the video now lol
@Ls3guy Жыл бұрын
I see you hooked that up wrong
@Gramdaddy390 Жыл бұрын
Looks that way to me too
@juanramirez-et8ie Жыл бұрын
The solenoid is upside down correct? So lines are all backwards?
@kyletice8112 жыл бұрын
If you are venting back into the same volume that you are using as source, couldnt you just t/y those two lines together at the solenoid? Ive always just seen it vented/exhausted to atmosphere will venting/exhausting into a possible high pressure system allow this to work?
@PistonsofFury2 жыл бұрын
Just to clarify, I'm venting into my air intake pre-turbo, so it's not pressurized. I could technically just vent to atmosphere and it wouldn't make a difference.
@TwinTurboLsx3 жыл бұрын
Where does it take it’s reference from? Are you using a standalone system like Holley?
@PistonsofFury3 жыл бұрын
I'm referencing the boost pressure for the wastegate directly from the compressor housing to make sure the gate sees actual pressure, and also to not introduce vacuum into the wategate diaphragm (and potentially tear it). And yeah, I'm going with the Holley TXMAX - it just made financial sense when factoring in all of the systems I need to support.
@TwinTurboLsx3 жыл бұрын
@@PistonsofFury I see. Ya I was just curious what pressure reading the system was going to make it’s adjustments off of. I didn’t see a dome pressure sensor. I too have the terminatorX Max system. Although I’m not quite done with my build. I think I’ve seen a video from sloppy that showed how he was able to make it read and adjust off boost pressure rather than some pressure.
@PistonsofFury3 жыл бұрын
I have a 2.5 BAR MAP sensor in the intake that the TX will use to gauge actual boost the engine is seeing. There may be a pressure drop between the compressor housing and intake manifold, but I can account for that in the tune. I'm also still deep in the build, but getting there... Good luck with yours!
@weduhpeople85042 жыл бұрын
How much pressure will those push lock fittings hold? Would it pop off at 40psi?
@HighTimesTrader2 жыл бұрын
No. The good ones are worth the money.
@HighTimesTrader2 жыл бұрын
Airline hose. It's the same thing that truckers use
@terryspaulding20002 жыл бұрын
How did you wire up the mac valve?
@PistonsofFury2 жыл бұрын
It just needs a 12V source and your ground goes to a PWM- output source on your ECU. The ECU then sends the PWM signal to activate the solenoid.