RadioMaster AG01 CNC Gimbals need a Bezel?! (viewer question)

[@tonymorgan328]

Thanks very much for that info. Waiting for mine to arrive.

[@MRdeLaat]

i got these fitted yesterday, without the light ofc. they feel soo smooth and its always dead center, youre drone wil be flat as a pancake the whole time you have betaflight on and see the drone in that menu

[@MCsCreations]

Great info, Lee! Thanks a lot! 😊 Stay safe there with your family! 🖖😊

[@HeliZero]

Hi! I installed my new gimbals yesterday and i did not use the bezels and it looks great.

[@OrbiterElectronics]

I didn't use the bezels either.. JUST BE AWARE FOLKS.. That removing the bezels to fit the new gimbals means that you are effectively removing a rather thick spacer from below each gimbal. So using the original screws to secure the new gimbals means that as I found.. the screws can be slightly too long, & they start to bottom-out before the gimbals are even tightened down properly. To help rectify this you can either use slightly shorter screws, or just add a couple of small washers on each or all of the gimbal screws. This will help secure the gimbals down AND prevent the screws bottoming out.. possibly damaging or stripping the plastic threads.

[@Painless360]

Great advice, thanks for posting.

[@MrJarrod]

I am going the same rout as well No Bezels. Mine are on backorder .

[@frankyflowers]

they need bezels that are springy and sink when sticks touch but you can feel it there. maybe some bumps like braille.

[@hookprobe]

will they fit jumper t18 ?

[@Painless360]

Not sure, if you can fit the RadioMaster standard gimbals into it then these should work....

[@Chris-vc1dh]

are the cnc much better than normal?

[@Painless360]

It is. Happy flying

[@mongranperspective4809]

Hello. I installed the gimbal LEDs and I was able to adjust the height of the gimbal handles to its highest possible to accommodate for the loss of resolution. I got 100% yaw left and I think 95% yaw right. 95% roll left and 100% roll right. While throttle and pitch are 100%. I think this is somewhat ok. What do you guys think.

[@mrmagoo600]

Hi MongranPerspective, are you saying that the LED set will limit travel?

[@frankyflowers]

i never even knew those were called gimbals

[@DronePlayground]

👍👀🇭🇷