Replacing Ignition Lock Cylinder 2003 chevy malibu LS

[@davezins111]

Great video. Thanks for the detailed and thorough description of the whole process. This saved me a bunch of $$$ and time taking my car in. Thanks again.

[@nickdowdy2161]

The tap trick got mine right away thank you so much, I've been in a parking lot for an hour and finally looked this video up

[@nickytwg4]

I went through multiple videos of the same issue my car was having, and I found yours the most helpful of all. Thank you!

[@zoukiller360tv5]

thank you so much!!! I hit it I trusted you and it worked wish I had seen this before getting it towed to my home. but i have the key in and it turns now i can get it fixed with a new cylinder on my 2009 malibu.

[@whocanitrust3337]

Thank you. This was spot on and worked exactly how you demonstrated!!!

[@walkermech11]

GREAT VIDEO. Is it the same Procedure on 2011 chevy malibu 2.4liter ls.? I lost my factory key and bought a new lock cylinder with key like the one in your video

[@josephhudson9122]

Will this method work for a 05 mailibu .?

[@lifesabitchthenudie1]

Would replacing just the ignition cylinder fix the problem of the dash lights and car not starting up? Or would I have to replace the whole ignition switch module? (Car does crank but will never start if dash lights don’t turn on unless I turn key off and on until dash lights turn on then car will start)

[@alexwisienski903]

Thanks Alfredo. Very helpful. Saved me $300.

[@psautomotive5530]

I’m glad to hear that 😀😀😀

[@donnaaquino4918]

Hey Alfredo I have a 02 Malibu the radio does not turn off when I turn the car off which drains the battery any suggestions that could help me out please

[@Gushers2276]

while driving all lights went out car tripped out, lights came back on car resumed as normal... the vehicle jerked a bit too and i assumed battery / alternator since all the lights were flickering but i think i just got damn lucky and the vehicle got signal back while moving got home checked my alternator and battery cables to start and then i thought ignition switch as well because i can already remove the key from it and the vehicle will stay running ( 2000 chevy malibu 3.1 ) tried to start it in the driveway and all sorts of crazy shit was going on gauges would lag and fly all over, vehicle would stall immediately. other times it would start up just fine. ty for the relearn instructions too replaced ignition switch and you have the best video! so good and to the point

[@terrihunt8130]

My car will still run with the keys out n plus when I'm driving my car will just cut off for no reason. The car battery will die fast n when I boost it off it will take a while for it to started back I have a black key for it n other key I don't know what chould be the problem

[@karenmckay5654]

Thanks for showing how easy it is.

[@alandanks8373]

How did you get your key to turn ? Been trying and trying, but I don't want to break anything.

[@ocielcarrillo5596]

I have the same problem with a 2001 chevy malibu. I have changed the lock cylinder but have not been able to reprogram the keys and won't start. The anti theft light doesn't blink. It is just staying on. Any suggestions?

[@slimsherman1333]

Thank you so much you saved us a lot of aggravation!!!!

[@photographer374]

What if the replacement lock cylinder doesn't slide all the way into its place? I did all prior steps, but the replacement cylinder won't slide all the way in. It did the first time but the key wouldn't turn all the way to the off position so I couldn't turn the car off. So I had taken it out now the cylinder won't go back in.

[@donjeff7060]

We're did u buy it from

[@chrispark7053]

Yes it worked thank you!!

[@LeagueofLegendsPreRelease]

how do i get a key fob for my 04 chevy classic?

[@cybersonic8472]

In your video you have the stereo removed. Is that required to get to the hole to depress the pin or did you do it for camera

[@chrisw2839]

Excellent instructions. Thank you

[@josesijoseorijinal1]

Muy buena información de como seguir los pasos para el reemplazamiento del switch 👍

[@psautomotive5530]

Gracias

[@davidgambler1591]

Hi, I got 2000 Malibu, turn key, dash lights up, no crank. After 75 tries, it finally started. I'm thinking starter, or ignition switch. It doesn't have a starter relay, does it?

[@psautomotive5530]

Hello David, it does have a starter relay. It could be the ignition switch, the relay or the starter itself. You can check the signal wire at the starter, which is the small wire, it should have 12 volts when you hit the key to cranking position.

[@davidgambler1591]

PS Automotive, I smacked the starter several times with a hammer and then it started. So I need a new starter, thx.

[@psautomotive5530]

Yeah that happens. Remember to hit the subscribe button so we can keep on making this videos, thank you.

[@jackfenn7524]

Do you have the Passlock system on your car? That keeps you from starting your car for ten minutes.

[@davidgambler1591]

jack fenn - it was the ignition switch, 4 minute repair.

[@jeremysmith356]

Thank you sir 🎉

[@DJCoop1]

What if i still can't get the key to turn?

[@jimcantu1487]

Good work!!!

[@msneedtoknow1]

Good job thank you!

[@johnthomas4577]

Thanks. Great Job!

[@psautomotive5530]

Thanks

[@a_mustache_of_great_repute]

Absoluty cannot get the key to turn. What do i do?

[@psautomotive5530]

Replace cylinder

[@trentosborn8835]

@@psautomotive5530 in addition to his comment above, I am having the same problem. Key is not turning. If you have to have it turned to ACC, but key won’t turn, what do you do??

[@WPGinterceptor460Interceptor]

@@trentosborn8835 what did you end up doin?

[@WPGinterceptor460Interceptor]

what did you end up doin?

[@oliviacuellar9641]

Gracias por explicar cómo encender el carro después de instalar la nueva llave estábamos tan frustrados por que no encendía !!

[@RS-el8oi]

So what do you do if after tried the relearn sequence it did not work

[@psautomotive5530]

It should work try it again. If not you will have to connect a scanner and scan the anti theft system

[@cjpp78ytube]

Weirdly I didn't have to do any relearn sequence at all. Car just fired right up after installation of new lock cylinder.🤷🏾‍♂️

[@thelastone8960]

Thanks man

[@psautomotive5530]

No problem 👍

[@fuqui035]

My brother replaced the cylinder on my Chevy because to banged the key hard

[@garyjohnson801]

I am a locksmith and I will tell you that I wouldn't have replaced the cylinder . I would have repaired it that way the customer would have one key to start the car and still unlock it and also would have been cheaper for the customer

[@chriseverett6383]

Gas station threw my key away hi ow do I put in acc position

[@alandanks8373]

I had a very similar issue with my old Toyota Tacoma, and the local locksmith saved me ! It was going to be alot more money because the dealer had to overnight the switch from California, then it would still need to be installed, then it would mean an additional key for the p/u. The locksmith just rebuilt the lock and the purposely left out the last set of tumblers so that it wouldn't happen again. Much less expensive plus I was still able to use the original key. Thank you LOCKSMITHS !!! Now PLEASE tell me how to get my key to turn in this Chevy. I can't do anything until that happens. Thanks !!!!

[@icee2943]

my key will not turn at all. suggestions?

[@psautomotive5530]

Replace cylinder

[@justinweldon161]

@@psautomotive5530 yes but how if the key wont turn

[@WPGinterceptor460Interceptor]

what did u end up doin?

[@WPGinterceptor460Interceptor]

@@justinweldon161 what did u end up doin?

[@danhahn5866]

will the new key open my doors?

[@redcloud5813]

No, keep your original key for door

[@WPGinterceptor460Interceptor]

tried for 2 hours to get the key to turn.. tried EVERYTHING, tapping, vibration etc etc etc etc... only thing I can think of next is to try and drill it out! anybody else have this issue and key just wouldnt turn.. LIKE ITS THE WRONG KEY!!!

[@Ason19]

A car place was trying to charge me $500 for this. I don't get why car people are so crooked and evil.

[@GetteCook-de9vk]

Eeeeeexactly!!!!😔😔😔😔why!??? I don’t understand why they rip us off. Thank this guy soooo much for being kind and sharing this information with us on a tight budget ❤❤

[@jarrodcoon9875]

Will you come tap on my key so it will turn

[@fuqui035]

Do not throw away old keys you will need them to open the doors you r. New keys won't p work

[@steezy_specs1989]

Hammer trick don’t work.

[@WPGinterceptor460Interceptor]

what did u end up doin?

[@steezy_specs1989]

@@WPGinterceptor460Interceptor so what I did to get the key out of the ignition was I noticed that on the shifter there is a button on top that allows you to switch gears. Well upon looking further into it and I believed I removed some piece from the center console and I used a quick drying silicone wd40 on the shifter cable and it allowed the key to be freed. The cable is getting sticky causing the key to be stuck like it thinks it’s still in gear.

[@jackfenn7524]

I have a few suggestions for you. First, wear a hat with a big American flag on it. Then, prepare a script for yourself, so that you don't have to fumble for words in your narration. Preparation is everything. Any tools you use should have the USA logo on them. You have a charming way about you, so viewers will automatically like you. Your voice is great, and your personality comes through strong. Nice video!

[@psautomotive5530]

Will take into consideration, we’re trying our best here. Thanks for your comment

[@xadam2dudex]

Use some WD-40