REVO 1836 Lathe Setup - Adjustments And Fine Tuning - Part 15

Laguna Tools REVO 1836 Lathe Setup - Adjustments And Fine Tuning - Part 15.
Subscribe to our email list for deals and promotions: bit.ly/3wICefj
►Contact us for more info: bit.ly/35UqV6M
►Subscribe now: bit.ly/2r5Czgc
►Instagram: bit.ly/2mph6wt
►Facebook: bit.ly/2qiHpXi

[@med1pilot1956]

This is the best and most helpful setup video I have yet seen. We will be ordering a new 18/36 here in the next few days, and this series was most helpful.

[@sapphodesigns2377]

The series of these videos was so informative on this product that I bought it with most of the accessories. I receive my lathe this week...I can't wait to set it up.

[@LagunaTools]

Glad to hear these videos were very informative to you.Thank you for your purchase and have fun. Can't wait to see what you will create. Feel free to send us a photo of you and your machine then we will send you a free laguna shirt. Thanks again.

[@reameswcoil]

These videos were so informative and well done that I decided to get this lathe...ordered it today!

[@calmwoodcreations3709]

I ordered one of these yesterday on the recommendation of a good friend. Now I'm trying to view everything I can find on setting it up and using it. Your videos are an excellent help. Now I feel I'm ready-- just waiting for shipping confirmation. Thank you so much!

[@LagunaTools]

Rad! Let us know if you have any more questions, and tag us in the work you do on Social Media!

[@calmwoodcreations3709]

@@LagunaTools--Thank you for the response! Soonest for shipping is early June. The waiting is the hardest part!

[@tmikeporter]

Excellent set of videos. I used them all to set up my new lathe. Very helpful. Thanks!

[@michaelogden5958]

What a workout! Nicely done!

[@sapphodesigns2377]

Thank you...I will!

[@sergebasque7689]

Hi guys! Nice video. You show us how to adjust the head and tail stock from side to side, but is there a way to adjust from up and down. I have just bought a 18/36 revo and my tail stock is lower than my head stock. thanks serge

[@Brangustx]

You don't explain the up and down alignment of the tail stock. If my tail stock is about a mm higher than the head stock, what is the procedure for aligning the points?

[@LagunaTools]

Lets Discuss. Call us 800.234.1976

[@pjenslin1]

I need some advise. When I drill holes using my tailstock (with or without Jacobs chuck) the quill becomes very wobbly when extended more for deep drilling. The holes are not good because of all the movement. Any advise?

[@LagunaTools]

Hi Philip. If you haven't had any luck fixing this issue, please contact our customer service here: lagunatools.com/resources/customer-service/ They'll be able to help you find a solution!