RV axle grease and brakes

RV axle grease and brakes - SURPRISE FIND

Рет қаралды 808

2 ай бұрын

Basic maintenance leads to a surprise find. Hope you enjoy. Thanks for watching!
-Ray
Links to products on Amazon:
Brake tools:amzn.to/4aQtHvx
Brake pin tool: amzn.to/3U6HrLu
Drum brake adjuster: amzn.to/4aQzC3P
Bearing grease packer: amzn.to/44hp9vG
Caliper grease: amzn.to/44diFOG
This page contains affiliate links. If you purchase a product through one of them, I will receive a commission (at no cost additional to you). I only ever endorse products that I have personally used and benefitted from. Thank you for your support!
If you choose to try one of the suggestions made in this video, you do so at your own risk. No information contained in this video shall create any express or implied warranty or guarantee of any kind. Any injury, damage or lose that my result from the improper use of tools, equipment or information contained in the video is the sole responsibility of the viewer and not Ray of all Trades. Please ensure that you take all proper recommended safety before attempting any project. Ray of all Trades assumes not liability for property damage or injury incurred as a result of any of the information contained in the video.
I appreciate each and every one of you!! Thanks for hanging out with me - Ray

Пікірлер: 11

@D3thM3tal 2 ай бұрын

Fantastic job of showing the important things to look for on a drum brake job - espically the nuances of the nut tension, greasing and how to properly adjust the drum brake.

@RayofallTrades 2 ай бұрын

Glad it was helpful and I appreciate you watching!

@dcharnas2592 2 ай бұрын

Nice Job! Very Thorough. Thank you for posting this!

@RayofallTrades 2 ай бұрын

Glad it was helpful and I appreciate you watching!

@OldCowboy450 2 ай бұрын

I use Anti seize, works for me, good stuff.

@RayofallTrades 2 ай бұрын

Thank you!!

@markw365 2 ай бұрын

There's a seal on the back of the drum, when you pump grease into the fitting and it comes out that hole, it's forced forward and will come out of the front bearing completely filling that cavity between the two bearings and push out the bearings. You pump grease into it until you see it forced out the front bearing, spinning the drum as you go. However if that seal fails and you don't see grease at the front bearing after a bout 10 pumps, pull the drum and make sure you didn't fill the drum with grease.

@RayofallTrades 2 ай бұрын

Thanks for watching! Yes that was my point. 10 pumps would not have filled that cavity. But also applying grease in the area of a bearing doesn’t pack it either. If you noticed my inner bearing was packed and the outer was dry.