Shark IZ201ukt Power Nozzle, dead, finding fault, Floor head same as IZ201uk, IZ251uk, IZ251ukt

Please DONATE a small amount to help me improve and expand on future videos, at the moment I do not have enough subscribers so am hoping people will be kind in donating especially if it has helped and saved them money.
Either go on my home page to see the PayPal link or copy and paste the following to go to PayPals safe and secure donating page, thank you.
www.paypal.com... I'm no professional but this video will show the common fault of the power nozzle being totally dead, no lights or anything.
This is the same as other similar models IZ201uk, IZ251uk, IZ251ukt.

[@derekwilliams2162]

Hi Adam., I had exactly the same problem, but my white wire had sheared off & black one about to go! Very very bad design, so I've replaced all 3 wires & job sorted thanks to your excellent video, keep up the good work bud.👍🏼

[@charlesgreasley736]

Thanks for showing how to strip the head down. I did this but the wires were okay and still the head worked intermittently. I guess there are always more problems than there are cures!

[@adamburton2165]

Hi, unless there is a issue on the connection’s then I would still inspect the wires going through the upright neck pivot, I’m sure if left it would get worse until it dies completely and then the broken wire would be more obvious, I haven’t yet come across one where the pcb or motor worked intermittently but electrical items can be annoying. regards

[@grahamandy0]

brilliant video Adam, I followed it step by step and in my case it was the black wire that was the issue ,cheap set of hex keys from amazon ,job done. thanks mate

[@tuntona5133]

This is a great video ,please can you let me know which torx screwdriver bit you used for the screws? I have exactly the same issues .Thanks

[@clarkedavidson5132]

What type of wire did you use for this? I have the exact same issue with mine I’m going to try and fix it. Thanks!

[@adamburton2165]

hi, I only used the wire that was there, basically I took the little panel off the back and the wire which had worn I cut near the connector so then it would slide down, (otherwise threading through a new wire would be very difficult) and then I cut a correct size piece to slot into place and used a heat shield sleeve to join both ends back, the wire between where it breaks to the pcb is longer so there is enough to use and repair, then obviously you join from original break to the rest of the wire to the pcb and using a heat shield again, so 3 joins but no need to use extra wire, that was how I done it anyway. regards

[@Max-xe5hp]

You can’t see what you’re doing! Poor camera work!

[@adamburton2165]

Try doing it yourself, or go somewhere else doing better, but if nothing stop complaining that someone is trying to help