Starter Clutch, Part3- Reassembly. KZ1100

[@michaelrobinson5577]

Thank you for your example on the bike and the word of the Lord!

[@benramirez8969]

Thank u brother for your help.and the words of wisdom.

[@richarrrdj]

I liked that Bible read....best part of your video. ..allot harder to change out starter clutch on my kz750 where you pull the oil pan etc.

[@toyetoyetoye]

How did you get those 3 bolts out to begin with? I may have missed that in your earlier video

[@rockinrobinbuddi2112]

So you didn't install the rubber damper before the big gear

[@WMDTVIDS]

Did you get this bike running?

[@russellgoverno8190]

WHAT SIZE BOLT DID YOU USE TO REMOVE THE ROTOR?

[@DougShoeBushcraft]

It's a special tool. People also use a bolt. I'm not sure what size and thread pitch. But also if using a bolt, you have to make sure it is hard enough

[@michaelcarey125]

I used the rear axle off another bike 18mm as far as I remember, the rear axle off the kz your working will do too.