Рет қаралды 18,379
Thank you for watching my tutorial on how to strip and rebuild a pull starter in a lt50 quad, showing how to strip and replace cord, reassemble and set up handbrake. all parts listed below.
4mm Pull Cord used ebay.us/NapVhh
Aftermarket starter housing ebay.us/z8VL3y
Genuine Starter housing ebay.us/ZCbfsx
Check out the previous LT50 videos
Introduction - • SUZUKI LT50 children's...
Part 1 - Wheel bearing - • How to replace LT50 fr...
Part 2 - King pin - • How to replace LT50 st...
Part 3 - Fuel tap - • How to test LT50 fuel ...
Part 4 - Fuel leak - • How to stop LT50 fuel ...
Part 5 - Axle bearings - • How to replace LT50 re...
Part 6 - Chain / sprockets - • How to replace Suzuki ...
Part 7 - Carburettor 1 of 2 - • SUZUKI LT50 part 1 of ...
Part 7 - Carburettor 2 of 2 - • SUZUKI LT50 part 2 of ...
Part 8 - Rear brakes - • SUZUKI LT50 how to rep...
Part 9 - Steering Alignment - • SUZUKI LT50 How to set...
Part 10 - Throttle Cable - • SUZUKI LT50 How to rep...
Part 11 - Brake Cable - • SUZUKI LT50 How to rep...
Part 12 - Pull starter - • SUZUKI LT50 How to rep...
Part 13 - Tear down - • SUZUKI LT50 full strip...
Part 14 - Brake lock - • SUZUKI LT50 brake lock...
Part 15 - Front Weight - • SUZUKI LT50 How I fit ...
DISCLAIMER: Links included in this description might be affiliate links. If you purchase a product or service with the links that I provide I may receive a small commission. There is no additional charge to you! Thank you for supporting this channel
please like and subscribe, also please follow me on Instagram to keep up to date with what's going on on my channel @ Martys_workshop