DJI Phantom 3 A/P OFDM receiver replacement

[@pavel1809]

thank you so much for the video was very helpful now i need to see another video how to remove the mount brake for the receiver i Have the same dji phantom 3 standard but do not have prosition module vps or receiver or mount brake i need help i m new on it i m traying to linking it to the remote because the linking button is missing

[@Keystonya]

Thank you for making this video! I’m currently replacing the OFDM module on my P3A. I clipped the cooling fan off of my old board and I’m getting ready to solder it on to the new board. My question is do the fan wires make contact with a single pad on the board each? I’m looking at the old board and there are multiple pads around the area. It’s hard to tell if the fan wires are laying across multiple contact pads on the board.

[@artek9808]

Do you know what are the symptoms of a defective receiver? help me please.

[@bobmarleyy1976]

Hi I've lost the order on which antennas need to be connected to the ofdm module.. I see 1 2 3 4 on the board but what are the associated legs numbers? Really appreciate your help

[@TheA8W12]

If you’re looking at the very beginning of the video where camera is on top and ofdm in the bottom; top left leg is antenna1, top right is antenna2, bottom right is antenna3 and bottom left leg is antenna4

[@anodastudio852]

If my remote cannot connect to drone must change ofdm?

[@jpmelmac]

hola donde compras la placa de reemplazo?

[@WolfRodrix]

hello, how can I check if my receiver its working?

[@uakron17]

What symptoms were you experiencing to swap the receiver? My quad took a fall from about 10 feet and landed in grass and since then, the controller will not connect unless I put an SD card in and run the firmware update before each flight. If I turn it off and back on, it won't connect without running the firmware again. It also won't stop beeping, two beeps at a time. I'm thinking something with the receiver module because there is a dent in the VPS housing. Any idea?

[@sujithtv]

I crashed my Phantom 3 4K into water and have been having similar issues after repairs. The problem is that the app keeps disconnecting from the aircraft. I have control over the remote and can steer the drone, but the app reports disconnection. I too have a dent near the OFDM receiver on the drone. Have you had any luck finding information on how to fix this?

[@MikeJCullen2]

It may be that your ESCs are damaged. DJI techs will have to diagnose.

[@WASHBUILT]

I have one and the light to bind is not there ... I checked the wiring and still no light

[@JSLR]

So would this fix the issue where it says 'gimbal disconnected'?

[@TheA8W12]

JSLR Productions are you able to connect to the controller? Meaning, is the first light on the left on your controller green when both, bird and controller are on?

[@iamwarren219]

kzbin.info/www/bejne/pqeQoaudbrh2m80 This solved that issue for me

[@305havana]

how do you know the antenna position ?

[@TheA8W12]

what do you mean position?

[@305havana]

TheA8W12 they are 1234 compass or antenna connected to that how do you know the order

[@udheasri257]

Sangat membantu