Triumph Sprint St 1050 Tank and air filter removal

Someone asked me to do a video on tank removal and airfilter removal I also cover the SAI in the video

[@netkongen]

You don't need to remove the plugs and tube. Just open it from the other side (from handlebar side) and slide the tank up right.

[@deep3805]

Is the orange connector on the bottom of the tank for the fuel pump?

[@floatybisquit]

Yea that’s the petrol supply connector

[@zx12rider]

I removed my tank a couple weeks ago to replace the filter. Lost my notes and not sure witch hose goes where. Can you post a pic or video or just tell me which hose/plug goes where? it runs but has a check engine with installing it the best I remember

[@floatybisquit]

The pipe with the little valve goes onto the right hand side and the one without goes to the left!

[@neiltwitchett3589]

The Sprint St Guy

[@kidda74]

I'm looking to swap my CBR for one of these bikes, any idea where I could fit my autocom system? It's currently under my seat but looking at that there isn't any spare room? o_O

[@floatybisquit]

kidda74 there's a glove box on the right hand side!! At the front near the screen 👍

[@kidda74]

cheers! 👍

[@gandalfthewhite6495]

Did you use a Harry Potter wand to get the front bolts off the tank 👍

[@floatybisquit]

Yes!!! Yes I did! 😀

[@michaelflores2506]

It does have front bolts on tank as well yes??

[@barrymoore3370]

No the front simply slides into a rectangular retaining holder

[@sethturner7089]

Left bike in rain now won't start

[@coony535]

WTF are you saying !

[@floatybisquit]

What?

[@k9togger]

"Not going to do it" Change the title of the video then. Total waste of time.

[@floatybisquit]

I didn't do it because like I said it's easy to do just the screws around the edge!!! I'm sure you could do it!!!!

[@micsierra806]

Steve Winn Total waste of time? He just took you 98% of the way there. For free. It cost you a few minutes of time. Probably best you take your bike to a shop if you need instructions on how to unclamp a sensor and how to remove a few screws.

[@barrythomas1616]

Try taking a few lessons on filming as its too close and is poor quality

[@floatybisquit]

It was 2016 mate filmed on my iPhone 1 gee

[@kentwiley1067]

Poor filming and commentary

[@floatybisquit]

Thanks for your productive comments!! Bet your channel is flawless!!