Great video. If you don't mind me asking, what is the official name for the offset tool you used to machine the side facing the chuck? I'm not having much luck finding it on google. Thanks!
@836dmar Жыл бұрын
Good job. Nothing brings out troll comments like turning drums or disks. It’s amazing. You could hand them two turned rotors - one of yours and one done on a brake lathe. Even with a micrometer they won’t be able to find taper or anything different between the two yet you are “doing it wrong”. Great video!
@machiningandtuning Жыл бұрын
Hehe yes there are troll everywhere and most of the time they have no idea what they talking about. I fully agree with what you say, doing it this way, without the rotor leaving the chuck from start to finish, it's pretty much the same thing, the last step in the process is to light skim the hub contact face, so it's like it was bolted to the brake lathe. Glad you enjoy the video, thanks for watching ;)
@pauloconnor7951Ай бұрын
Spectatorism. Lazy spectators not involved in life.
@borneoaxiadriver Жыл бұрын
Hi. May I know if you are using special tool bit for this? Currently have 10% Cobalt with me, but my foreman said that it's not suitable. Not sure why he said that.
@machiningandtuning Жыл бұрын
Hi, for this job i used some carbide tips, but i think you can get the job done with hss co10. cast iron Is very abrasive on the tool tip, i think that's the reason why your foreman said that. If you can use carbide It's for sure better due to it's higher wear resistance.
@borneoaxiadriver Жыл бұрын
@@machiningandtuning thanks for the input sir!
@machiningandtuning Жыл бұрын
@@borneoaxiadriver no problem man 👍🏻
@andrewwilson6085 Жыл бұрын
I always use tungsten carbide tipped tools. Lower R.P.M. gives less vibration. Getting the thickness parallel is crucial
@therealspixycat2 жыл бұрын
Well done! This is the proper way to do it
@miguelzaratesanchez82202 жыл бұрын
Verificas que esté dentro de la especificación técnica antes y después del rectificado?
@machiningandtuning2 жыл бұрын
You mean the thickness?
@ayawkona5545 Жыл бұрын
Traditional resurfacing is the best
@marcinmartinusАй бұрын
Super. Na nowej mialem 0.2
@andrewwilson6085 Жыл бұрын
Method is good, but a more rigid cutting tool is needed to give a better, more accurate finish.
@joaoap.mil.40142 жыл бұрын
Vc tá torneando o disco só preso na placa tá errado eu torneio o com o cubo do veículo junto.
@toninhoemariarondina16248 ай бұрын
ai quando vc colocar no veiculo vai ficar torto mas ele deu um passe dentro onde encosta no cubo fica 00
@Ник-л9х6ъ2 жыл бұрын
Что бы так протачивать диски Нужен идеальный станок и патрон Обороты большие, плоскости не будет
@joaoap.mil.40142 жыл бұрын
É mais presiso.
@pattime2laugh599 Жыл бұрын
No commentary sucks
@rxsyete10 ай бұрын
That is how to do it if no brake lathe available 🫣