Turning Thursday - Turning Tools

[@dolphlundgren2820]

Sad beans you never even used the crown m42 cryo tools . I was curious about those.

[@adrianolsen-woodhamwoodtur4980]

Excellent Colwin...many thanks

[@georgepauselli769]

Hi Colwyn George here can you show how to use negative rake on the tool rest some time please thanks

[@SKYWALKER566]

....how much money they cost all the chicell?

[@axminster]

Hi there, you can view these sets on our website - www.axminstertools.com/crown-cryo-m42-turning-tool-set-105915 and www.axminstertools.com/axminster-craft-woodturning-tool-set-106153

[@woodmum]

Do you know when the axminster tools will be in stock again?

[@jaylijoi2060]

Will the current Chuck jaws fit the older axminster Chuck? I think my Chuck is over 20 years old.

[@axminster]

Hi Jay :) Colwin doesn't see you having a problem with this. However, please contact our Customer Service team who will be able to advise - www.axminstertools.com/contact

[@CJPhillips6648]

Can I use carbide tools on bowls?

[@axminster]

Yes you can. Colwin recommends the Easywood rougher 109253, which is designed for the outside, and finisher 109311, for the inside

[@999pil]

How or where do I view the live broadcasts? The links on Axminster's site return page not found errors

[@axminster]

Hi 999pil, the videos are live on our Facebook page - facebook.com/axminstertools :) I hope this helps!

[@billkroulek3814]

Are any of them chyo tempered

[@axminster]

Hi Bill, yes the Crown M42 steel tools are Cryo treated, but the Axminster starter set are HSS. I hope this helps :)

[@philipvale1674]

Hi very good 😊 but I can not cannot hear you very well I've got the volume turned up quite high to maximum on my iPad might be best if you have one of these little mike so go cannot hear you very well I've got the volume turned up high to maximum on my iPad might be best if you have one of these little microphone which go over your head or something it's easier to turn it down, I can hear the person on the filming recording system better than I can hear you. Phil from the Moulin in France

[@sk13ppy]

Please improve the volume, it's too low!