Unlock the Secrets of Torch: Essential Tips for Maximum Performance

[@chrisguice139]

Gotta respect a man that has enough spine to admit a mistake instead of hiding behind a lie.

[@SirCarlosMusicBMI]

I Love How you Have a passion for what you do. Blessings, Carlos ✝️🙏❤️😊🇺🇸

[@TaylorWelding]

I appreciate that Sir Carlos

[@petethesquatchie]

Great Info Chris! Now I gotta get the torch out and cut up some stuff and weld together...I'm getting rusty again.

[@commietube4273]

I thought of you yesterday while cutting into a steam line that had just been shut down and blanked out. I noticed my flame was to hard so I brought down to neutral and adjusted it. Man a hot steam pipe doesn’t need much to blow a hole. Thx Taylor.

[@Truth2Truth777]

Great work Chris!

[@davidbranham3042]

Great video! Keep em coming.

[@scottjune3554]

I love these videos, brother thank you

[@brent8922]

Man youre just full of knowledge! Love the videos!

[@TaylorWelding]

Glad you like them!

[@MBwelding]

That is genius I will have to give that vacuum bag a try I have a 50# of 8010 and I just don’t use it that hard anymore so it’ll be a good way to keep it good longer

[@TaylorWelding]

I’m going to as well. 8010s go bad so quick or maybe not bad but they just don’t stay new very long.

[@James-fs4rn]

👍 thanks for sharing

[@masterexcavator101]

Safety reflection markings on rails.

[@trophbrwntrouthunter]

The restart tip was good, starts and stops for welding and torch cutting, is what challenges most guys.

[@chargermopar]

I made a welding rod holder from PVC pipe with a threaded cap. I fill with nitrogen and it stays good for years.

[@TaylorWelding]

That’s a neat idea

[@chargermopar]

@@TaylorWelding I used a tire valve pulled through a hole in the PVC. I need to make a video on that.

[@wadepatton2433]

@@chargermopar Easy enough on the tire valve-no video needed here.

[@waynespears5664]

This guy has nick names for just about everything he does,the best one yet is Lip Stick and pocket knife which one do you carry.........................Fort Worth,Tx😂

[@TaylorWelding]

lol That's a good one

[@ericelder2962]

Thumbs up for the ed bassmaster plug ❤

[@TaylorWelding]

The best!

[@Mechanicalcircus]

Psh

[@bsquadrider]

Another one full of good info! What size tip do you like running for saddling pipe posts?

[@camriedesel1202]

How do you lay out the coping lines on the pipe? You got a stencils

[@tp8030]

What's your guide to coping 4 inch? The pattern.

[@josephrobertsirgo4019]

YEAH BUDDY!!!!!!!

[@giulianogiardina857]

To stop the torch you should close the acetilene fist and after close the oxygen. Otherwise the torch make that *boop * 4:10

[@jackowens9440]

Hay dad you was talking about welding rods get some gel packs that takes morster out like comes in shoe boxes seal 3 or 4 up in rods will help

[@dholden93]

I vacuum pack my 1lb rolls of mig and fluxcore wire to keep them from rusting.

[@RichardWiazardry]

What are the pressures you set your gages to?

[@TheRitchieLeeShow]

What did that transformer cost ya 😢 Got a tip here get some head lights on that kabota😂

[@vickiehat1074]

👍

[@robertyoung4523]

Only joking.