Vespa px 200 changing engine mount rubbers

[@garyhsuhsuktm]

The good thing is: thank you for making g this tutorial saves my day. The bad thing is: mine is also broken so I need to watch your tutorial to fix mine.

[@Nordicexplorer1]

I hope you’re helped by this video. Thanks for watching, I’m sure you will change them without problems.

[@lucab1733]

Thank god, this happened on my smallframe and I thought I shot the bearing and damage the transmition also since it's on the same shaft

[@stevekelly6065]

Love your videos. Can you please do one on how you use the jack to lift the Vespa off the ground please

[@Nordicexplorer1]

Thanks for the feedback. Sure I can do that. Stay tuned and I will fix that in a couple of weeks.

[@craigcooke9308]

Great video, rather jealous of your garage 😉

[@Nordicexplorer1]

Thanks 🙏. Yeah it’s a nice garage with some good space .

[@anthonyavorio7029]

This video has a cliff hanger at the end...( will the wobble be fixed, tune in ) but this give me time to get a cinnamon bun and coffee ready....

[@Nordicexplorer1]

It’s fixed

[@alfredferdinandsloof8399]

nice job, and you sure have a nice man cave there 😊

[@Nordicexplorer1]

😁thanks

[@MarceloISB]

Great video, thank you! i was just prepering myself for do the same operation , also without taking the engine out. Now i have a good idea of how can turn out. Also i notice the vespa goes very unstable and woobling on the road over 70km/hr. I hope it improves , is very scary on windy days. How turn out for you after changing the rubber supports?

[@Nordicexplorer1]

Hello. It came out great. Make sure to check that your upper and lower bearings in the fork are tight. And the bearings in the suspension arm can be bad too.

[@Nordicexplorer1]

And of course always check that your rear wheel is tight.

[@domufflegere]

Does the methal tip of the new rubber need to sit in the hole of the frame? I have the same ones but my hole in my frame is the samr size as the ones in the rubber. The old ones were the same but not sure if it suppost to be like that.

[@Nordicexplorer1]

@@domufflegere they’re not going to sit in the holes of the frame. The metal tip should be pushed against the frame

[@domufflegere]

Ah ok ty. My new engine side rubber is a little bit to deep in the engine so the engine itself is attached to the frame. You think thats bad?

[@Nordicexplorer1]

@@domufflegere normally the metal tip is sticking out a bit from the engine and then it should be really tight to get it in to the frame. So I would say that the engine itself should not be in contact with the frame.

[@domufflegere]

@@Nordicexplorer1 hmm then i have to get them out again god damn. Probably gonna vibrate then too much

[@Nordicexplorer1]

@@domufflegere seems weird that they are too far in, have you maybe got the wrong ones? Normally the pipes of each rubber meets in the middle of the engine so that you can’t push them too far in.

[@babercobaig9844]

Dear Sir Which number of tool that i need to buy to ipen the exl

[@anthonyavorio7029]

Sound got muffled a few times during the video...don't yah hate when that happens....?

[@anthonyavorio7029]

Yep, that's quite the wobble..

[@Nordicexplorer1]

That was nothing compared to when the rear wheel and the steering column was loose also 😁