Vespa Smallframe Clutch Plate Replacement

Vespa Smallframe Clutch Plate Replacement
www.scooterwest.com/deluxe-cl...

[@sanchezable]

Keep up the vintage videos. I know there is not a lot of us. And most of us don’t know how to use computers. But these videos will be useful for years to come when these become popular when they become rare.

[@baddarkvader]

The last time I performed this on a small frame was in 1984 in my best friends kitchen and surprisingly I remembered it so knew your next step to my surprise.

[@Vespanation]

This video was so well done. Perfect descriptions, step by step, great video skills, just the best.

[@narrischernarrischer9204]

Thanks for the Video!

[@robertfields4836]

Watching from Ireland,

[@rosewell1983]

i like these videos. 45minutes of entertainment. Not just 4-5min or 15min.

[@spencerpayne2464]

Lovely smallframe now Robot, keep up the video's. If it were mine I'ld have to 75cc or 110cc it.

[@terrylee3788]

Great video. Always good to learn how to perform work on your own equipment. Thanks.

[@PhillipBolan123]

Very informative. Great video. Well done Robot

[@rod_r]

Great video. Just about to do this myself so perfect timing ! I bought a clutch holding tool, but watching this, I just realised the tool wont work with the clutch in place because the clutch covers the tabs that the tool is supposed to sit into....will have to try the copper coin

[@dodgydruid]

The old time honoured way was to soak the corks in oil for a length of time to maintain full penetration of the oil into the plates, I still use a ziplock bag whenever I does mine lol

[@vivaldi915]

Very nice. Thanks for sharing mate.

[@jaalgr]

Great video robot

[@efendi171]

Well done!

[@gmashe]

Thanks for that video. Really useful and makes it all too easy. However, I have a question - I'm new to smallframes. What would you suggest where the wheel hub - the blate in front of the brake shoes - doesn't want to come off? I tried loads of penetrating fluid, a puller and a heat gun and the thing just won't budge. I'm afraid to use too much brute force of a puller. Short of stripping the engine and splitting the case, any bright ideas??

[@KipBurbank1]

Thanks. Good lesson

[@yopifnuchannel8140]

Amazing 👍

[@jacgesjohn9058]

How to remove the clutch outer out from the case?it is necessary to go from the other side of the engine?

[@tianchongsun9867]

Why do you apply oil on the clutch plates?

[@eigner-9002]

how to remove that primary and secondary gear?