Installing the crankshaft in a 1.8T engine - for my 944 engine swap project.
Пікірлер: 23
@jostsimonisek52484 жыл бұрын
Watching all the way from Slovenia. Good work man. I have a 1.8T project as well, so your videos really help me.
@seljaaa65523 жыл бұрын
Pozdrav iz Maribora ;) kak je kaj projekt? jaz sem glih dobil blok in glavo nazaj od majstra, začnem sestavljat kmalu :)
@ryancounts81312 жыл бұрын
Thank you for covering the Thrust Bearings. It's hard to find detailed information sometimes.
@hoffa25863 жыл бұрын
Excellent thanks for sharing, I was just trying to wrap my head around thrust washers and how that setup works on a watercooled rabbit mk1 1.8 end checking end play.
@wibmag4 жыл бұрын
Love these videos! Thanks!
@ruialmeida52173 жыл бұрын
excelent knowledge
@user-jq5pl8zi9z4 жыл бұрын
شكرا جزيلا
@SirDubmonster2 жыл бұрын
Do you need to use new bolts for the crankshaft? Does it matter?
@vandettabuilds66414 жыл бұрын
The adapter plate you have designed for the 1.8 t do you think I might be able to buy one from you? I am really interested in doing this swap ?
@vsvenson4 жыл бұрын
Yes, a few people have asked for it - as long as I'm happy with it, I'll offer it for sale.
@tomaszwojcik56393 жыл бұрын
looking at what you're doing and this is how it should be done. btw, can you explain how did you clean and get block painted, tha
@vsvenson3 жыл бұрын
My machine shop that did the cylinder honing cleaned and painted it.
@cimfur Жыл бұрын
Hello Van how did you remember which fasteners go where. Any chance you know where to get diagram or specifications on that?
@vsvenson Жыл бұрын
It just takes counting and measuring - and making sure every fastener has 1-2x diameter of thread engagement. E.g. if it's an M6 bolt, expect it to have 8-10mm of thread engagement.
@cimfur Жыл бұрын
@@vsvenson thank you very much for the reply and the videos. Currently rebuilding this engine and found your videos helpful.
@billyc25722 жыл бұрын
Did you realize your mistake when you put the squirters in too soon? Did you break any during the honing process? Lol
@jordrider19172 жыл бұрын
Where baby tools come from 3:30
@autoxer19704 жыл бұрын
I noticed the angle indicator was also possibly measuring the movement and flex of the engine stand. Does that device account for that? Also, I’m bringing my 944 over. ;-)
@autoxer19704 жыл бұрын
And thanks again for producing these videos!
@vsvenson4 жыл бұрын
Yes, there is a little flex in the stand... I try to pre-load the breaker bar enough before resetting to zero, but it still might be a degree or two off. But that should be within tolerance. :)