VW Passat Variant B8 3G2 3G5 2015 - trunk/boot lock replacement - Kofferraumschloss ersetzen

[@oOKingpinOo]

Danke für die Arbeit... Mit deinem Video war es leichter als ein Ikea Regal ...❤

[@pan7285]

Thanks for all the tips on this video. I've just completed the same thing on mine, but found the lock completely jammed and don't have a vice, so couldn't go to town on it... Instead i dismanthed the lock as much as possible (motor out etc), then sprayed the whole thing with electrical contact cleaner. Lock instantly freed up and opened with the manual override latch, which it hadn't done previously... only wish i'd tried that before hacking away at it for 40 minutes!!

[@alik367]

Good effort. Did mine last night using this method to free the lock when off the car. Bit of wd40 and tapped the lock a few times seemed to unbind it so the manual unlock worked. Thanks

[@Ruslan.T973]

Danke dir, du hast mir paar hundert Euro erspart 😎👍

[@michaelhopps2169]

Have just done this job with the boot lock jammed. Once you have removed the two screws from behind the warning triangle and inside the pull down handle you can remove the back panel easily. Disconnect the lead from the lock and undo the two nuts holding the lock and the boot will open. You still have the problem of the lock attached to the locking bar, but simply dismantle the lock - firstly removing the three pozidrive screws. remove the motor and be pretty brutal with the rest. Use a drill to weaken plastic areas but be careful not to damage the shroud the lock is held in. Once enough bits have been broken out the catch will release. Tip - buy a new lock before you start - the old one was jammed anyway. Hope this helps.

[@The_Touring_Jedi]

Did you consider looking that button in the gloves compartment? There is button kill switch for trunk...I saw many people missed that and changed trunk lock which was fine...

[@michaelhopps2169]

@@The_Touring_JediThanks. But no kill switch on the UK models. Mine is 2016 build.

[@LuRifaX1337]

Thank you so much! It worked and I saved alot of money. Used full force to destroy the old lock.

[@mmozeegmbh2316]

nice entlich die lösung gefunden !!!!!!!! welches schloss hast du Neu ein gebaubt? gibt viele ab 40-120€ was kannst du empfehlen

[@carrepairvideos3226]

I brought a new original lock to be sure everything worked smoothly - and not a used one. :)

[@majstorivan4805]

This is the best video on web. My experience: I had total lock failure where lock grabbed hook permanently! What is solution for this? To dismantle whole bloody trunk! Removing of trunk internal plastic cover is not easy and I guarantee you hell in removing those 2 trunk handle screws(you will curse German engineering). Once when you removed it you got to dismantle the boot lock and after than you need to take bootom boot plastic so you have acces to hook screws. Once when you dismantle the hook you will be able to open the trunk! But now you are in real problem! Why? Situation 1: If you have bought new boot lock and hook than there is no problem at all. You need to cut off the hook with dremmel or grinder, and put evereything back(it is not easy to put evereything back either- some plastic connectors will probably permanently crack!). Sitation 2: If you have new lock but you did not bought new hook(you want to keep the old one) than you are in serius shit! You got to cut or dismantle lock from the hook! This is PITA job if you wanna keep lock plastic intact! It is not simple job like in this guy video at all! You cant take boot lock plastic off untill you cut of the mechanism that permanentoy stuck on hook!(don't ask me how I did it but it lasted long time! You will curse German enginering and Italy workers who made this OEM lock for VW.

[@vanTafel]

Thanks!! Great Video!!

[@SpangeBatta]

Nice video, thanks same issue here, on VW Passat variant GTE, fixed with this video, size key is TORX 15!! 🔧

[@dura911ilidza]

Tack så jättemycket min vän 🥰🥰

[@dura911ilidza]

Fixat idag 👍🏻 🇸🇪

[@severianttila8987]

90 mm tx20 bit combined with wera zyclop mini ratchet is perfect combo for trunk handle screws

[@БогданДуткевич-й3з]

Дуже дякую, зумів своїми руками все зробити

[@СергейПрядко-щ5о]

Як саме відкривали крюк всередині?

[@norm86peterson]

kennst du zufällig die teilenummer des bügels? nur falls ich das schloss nicht geöffnet bekomme. vielen dank für das video!

[@carrepairvideos3226]

Hi.. The OE number for the "bügels" is 8V0 827 507 G :) In Denmark its around 27 EUR

[@rusenaydin5300]

Wie haben Sie es vom die auseinander genommen den schloss

[@superkleiz]

Tailgate on my b8 stops half way up when i open it. Do you know what could be wrong?

[@stefanneagu3513]

Thanks for helping

[@rimvexrimvex5180]

Cant find online or on part

[@sele1966]

👍

[@rimvexrimvex5180]

Hi.what is lock part number please?

[@carrepairvideos3226]

Hi. The OE nummer for the lock is 5TA827505D. And the “hook” where the lock goes in is 8V0827507E.. Hope you find it. :)

[@rimvexrimvex5180]

@@carrepairvideos3226 mine is different number but looks the same.there is solution if you drill 1cm hole but now its too late

[@cocalarusnk]

Rimvex Rimvex Hi, can you be more explicit? I think I have the same problem, when i push the Vw badge it make that opening sound but it didn't open. Tnx

[@rimvexrimvex5180]

@@cocalarusnk get new lock

[@tomislavlisak7296]

@@rimvexrimvex5180 Can you please describe this a bit? I have the same problem. Is this 1cm hole that you are mention for easer unmount or solution for not changing lock? thnx

[@jorgeferreira6937]

You skipped the most important part, how did you 'destroy' the lock😐. I cannot get the latch to release for the life of me 😡

[@carrepairvideos3226]

With a hammer and screwdrivers to break it up

[@stefanhousen5057]

@@carrepairvideos3226 Have the same issue. Have it on my workbench with plastic trim. First, can i remove the plastic trim when the lock is still locked? Second, i really can't open it. I have one screwdriver in the white plastic, another one jamming in to the lock?? Do i have to use a disccutter? i.ibb.co/hVBfJMh/IMG-8155.jpg)

[@lukeandjudeshow9274]

After removing the motor and plastic components from the lock I used a large screwdriver to gain access to the catch inside the unit hidden by the top metal plate, lots of bending metal with the screwdriver but minutes later hey presto!

[@stefanhousen5057]

@@lukeandjudeshow9274 thx, managed to open it!

[@majstorivan4805]

This is the best video on web. My experience: I had total lock failure where lock grabbed hook permanently! What is solution for this? To dismantle whole bloody trunk! Removing of trunk internal plastic cover is not easy and I guarantee you hell in removing those 2 trunk handle screws(you will curse German engineering). Once when you removed it you got to dismantle the boot lock and after than you need to take bootom boot plastic so you have acces to hook screws. Once when you dismantle the hook you will be able to open the trunk! But now you are in real problem! Why? Situation 1: If you have bought new boot lock and hook than there is no problem at all. You need to cut off the hook with dremmel or grinder, and put evereything back(it is not easy to put evereything back either- some plastic connectors will probably permanently crack!). Sitation 2: If you have new lock but you did not bought new hook(you want to keep the old one) than you are in serius shit! You got to cut or dismantle lock from the hook! This is PITA job if you wanna keep lock plastic intact! It is not simple job like in this guy video at all! You cant take boot lock plastic off untill you cut of the mechanism that permanentoy stuck on hook!(don't ask me how I did it but it lasted long time! You will curse German enginering and Italy workers who made this OEM lock for VW.