Beltin job 👍

I look after a fleet with quite a few of these d max's, theyre a cracking jeep in my opinion, give a lot of bother with rear main seals from 2010 to 2022ish, seem to run the same powertrain, but even thats such a handy job, very rarely see them give any other bother. Keen to hear your opinion Baz. I know they dont have much spec but in terms of reliability, has to be top 3 for me👍

Far better than a scattergun approach!

Love your videos! The way these modern vehicles are designed to break really boils my p**s! Why does a sensor need it's own module? Why does it need to be mounted under the vehicle where it will corrode? why is is so expensive? I wonder. It's all done by design. Extortion. When these vehicles start to age and cost a lot of money, people will go and buy another one which is exactly what they want. In my opinion, you are better off sticking with your old banger for as long as you can because no matter how much goes wrong with it, it will still probably be cheaper than fixing lots of this type of stuff, or 1.6 cdti timing chains etc. newer no longer means less expense on repair work. On another note, I've been outside in the freezing cold the last few days putting an engine back in an R53 Mini Cooper S. Oh what fun! 🤣

BAZ FANTASTIC THANKS

You should wear a cap with genius at work is it your garage baz best from Manchester 😊

These faulty NOx modules always have corrosion inside when you open it. They need to seal these things better...

Nice video baz Keep warm and have a nice hot cup of tea

DiagnoseDan would not be proud with your 100% sure diagnose Baz. Just because there's CAN signal doesn't mean is the right one.

I didn't understand this channel his videos are very helpful however when you reach out to him through emails him never responds how do you actually get him to fix your car if he never responds?

What about if one side is blowing hotter than the other side

More little nugget passed on Baz, great stuff. The cost of these sensors is outrageous! Have a good weekend 👍

I love your videos. It is good mechanics job. But did you not get anykind of heating in your workshop?? Here in denmark we could not get people working if there is cool. In my own workshop i have heating in my floor, and it is 19 degrease celsius. Keep up the good work and show some more specieltools.

I do like your like for good tools them pickler tools and that little snap on battery wrench well actually you have some fantastic tools keep up the vids Baz

superb vid . dunno how much you know about astra van specs . i have managed to get the full xp kit to fit my mk 5 sportive

Happy that you remove “most” of those leaves from the shuttle as they were worrying me (LOL)

great diagnstic skills usual mechanics just change things

Another great vid baz and nice little bit of kit you've now got yourself. Hoping you're well in health and bring on 2025!

Great vid Baz again!! What’s the company name for the test light please 🙏 if you don’t mind.

Top job Baz! Where did you get the TopDiag P200 from please mate? Cheers! 😁👍

Ps to all the comments about the cold. Buy a bloody hat,im from yorkshire are the welsh really tighter than us? I know the scots are😂

Clear explanation, no messing about, brilliant video as always Baz. Have a good weekend.

No Heating Saturday Working i hope you are getting paid a fortune !

We’ve been doing these day in day out on the Merc sprinters ! Good work baz 🙌🏼

The Techs at the dealership where usedI worked would not put up with those conditions. Good on you😊

That is a cold spot where you work, makes me shiver just looking at the open end on the building there 🥶

Cracking job Baz. You just wanted to show off your new tool in action, great tool by the way.

Ello Baz, i would also do a Ohms test on the Datalink / CAN Bus system, i would expect to see 60 Ohms of resistance ( the voltages maybe there on each CAN Bus wire, but when tested using the resistance setting, it may show a different story /plus wiggle the wires ) more so with it being invalid data received from the NoX sensor. Hope this helps you or someone

Absurd price. Not long ago that sensor was a whole used vehicle with a years MOT.

Great job as always Baz, have a great weekend 👍

Where did you say that test load light was from...It was not very clear in the video? Thank you

It's bloody cold in that garage get the boss to put some heating on!

nox sensor 2 heater circuit fault on my insignia, been resetting the code every other day for a couple of months , so it still does its DPF regens, its on the to do list, bloody expensive though as you say

And don't buy cheap aftermarket ones, there crap.

90s cars much better they just rust haha

Who knows what make engine this is

I have always changed brake fluid every two years, but I’m curious why the dealer didn’t change the fluid for the owner of the two year old Tiguan. Probably before your time Baz but back in the mid to late 90s you could buy (at a premium price) synthetic brake fluid that didn’t require such regular replacement haven’t heard of it since?

I have always changed brake fluid every two years, but I’m curious why the dealer didn’t change the fluid for the owner of the two year old Tiguan. Probably before your time Baz but back in the mid to late 90s you could buy (at a premium price) synthetic brake fluid that didn’t require such regular replacement haven’t heard of it since?

U ponedeljak me to čeka

Hvala za uputstva

Can i get the kit on the f10 2015?

Hi do you know if the f10 520d part number 2015 lci mine cracking

Modern cars are SHIT.

Baz your knowledge is unreal you no ever job some mechanic or mechanical engineer fantastic

Jesus, what a job to get done! My Fiesta is coming up to the 8 year mark with 38K on the clock; I'm not risking it after watching this, i'd better get lubed up 😞🤷‍♂️

So glad im not a mechanic anymore.

Wow what a bodge, i dont know who makes the original clutches on thekiaand hyundai cars but they are not the best. Hope the luk rep set is a nice light clutch that will out last the car

Wanted to watch this but swirling in & out side to side shaking camera movements made it impossible.

I had a Toyota Yaris which with regular servicing (basic consumables) had done almost 200,000 miles without any issues, before I sold it, so I I think I'll be sticking with the Japanese brand.

Baz, You've done so many of these now. You Make it look so easy. I really admire you for your level of your skill and that your cool as a 🥒. 👌