2015 Chysler 200s 3.6 Upper Radiator Hose Replacement.

how to replace 2015 chysler 200 radiator hose

[@freddyortiz4583]

Thanks for the video. My daughter had the same problem this weekend. Used part number and got hose. It all worked as intended. Thank you.

[@bgmgio]

I got the same car but mine is overheating can’t tell where it’s leaking from but last it over heated I replaced the lower radiator hose and I went a year without no overheating but I recently got a alternator change done to it do you think it perhaps tell me could be the problem I replaced the thermostat the water pump and the radiator all last year I would really love to get your feed back ❤

[@keyzena]

would've been nice to see exactly how you disconnect the hose

[@abdelcarfix2770]

One clip use a pick or flat screw driver and pull the clip up hold hose and twist gently and pull off

[@abdelcarfix2770]

Other side is clamp

[@tannerotis]

Thank you but you do not need to replace the quick connect. The new hose slides over the inlet pipe and you just use the supplied clamp. That’s from the the mouth of Chrysler

[@sneed30]

So that quick connect will fit my 2015 chrysler? On orileys website and it says it won't fit my year.

[@abdelcarfix2770]

You mean for the sensor? Yes some I had to remove the old sensor and hook it up to the new cooler because different connector

[@sneed30]

@@abdelcarfix2770 I put that part number in on orileys website and it brings up the part but it says it doesn't fit my 2015 chrysler 200 c 3.6L

[@abdelcarfix2770]

Go with dealer one its updated one

[@freddyortiz4583]

I got mine at O’Reilly’s today. Worked like a charm.

[@kevindacey7966]

Yes did mine today. I put a clamp on broken piece it held for 2 days but let go. Part arrived from amazon while car was still warm. Iwas able to get broken threads out of hose and then squeeze hose to get metal ring off. I used existing hose with a new clamp and part worked perfect.

[@RicardoLambert]

Thought you would show the finished product I'M DEALING WITH THE SAME ISSUE

[@abdelcarfix2770]

Dealer only part I couldn't find it anywhere also its simple job

[@RicardoLambert]

@abdelcarfix2770 i just figured it out. Thanks for helping dumb people like me bro.. I bought the hose from the dealer special order. The picture had the quick connect attached. When i picked it up it didn't. Got the quick connect from Auto Zone. Bout to hook it up now. Is the hose that connects to the radiatior easy to get to???

[@abdelcarfix2770]

Yeah not that bad if you have the right plier

[@abdelcarfix2770]

Put little coolant on the quick connect o ring before install it helps seal better and no chance of tearing the o ring

[@RicardoLambert]

@@abdelcarfix2770 THANKS FOR THE HEADS-UP

[@whatitmeanstome]

Is that a 26mm for the new connector?

[@da2875]

Did you get the right one.

[@williamsmallwood2629]

U didn't show how 2 fix it