CARVECO simple 2D design and machining for beginners

[@rafikshaikh7530]

Thank you sir

[@rogerwebb9600]

Welcome

[@khalidsingh7950]

Loving it Roger .

[@rogerwebb9600]

Thank you, for watching, Please subscribe and forward the video on to a friend, Australian Inventor Roger Clyde Webb ;-)

[@TheUglyVector]

Roger, replace the "Cut...." w/ numerical order. Sorting your 'cuts' by number makes it easier. Should you have to add a cut between just add a letter after it. i.e., 01, 01a, 01b etc. Make sure the 0 is before the 1 etc, otherwise it sorts all funky.Nice video on starting Carveco, Im just learning it myself and found it quite useful. Cheers!

[@rogerwebb9600]

Thank you, for watching, Please visit my Patreon page, subscribe and forward the video on to a friend. Roger Webb ;-)

[@CCaraway]

I just purchased Carveco Maker Plus. I am having trouble following your instruction. Doing a inside offset with fillet corners seems not to be a option. All my options seem to be different. Any advice would be appreciated.

[@rogerwebb9600]

I will have a look for you.

[@briansowerby624]

Hi Roger, I have just purchased a copy of Carveco, following your video. However I am unable to locate the video tutorial webpage you were demonstrating in video 314. Can you please let me know the www, ........... regards Brian

[@rogerwebb9600]

Hi, Brian, here is the link. kzbin.info/door/P0v3oQjLKV3e3gHWYyFqXQ Thank you, for watching, Please subscribe and forward the video on to a friend, Australian Inventor Roger Clyde Webb ;-)

[@hameddesign70]

Im using artcam right now , and this video appeared in my recommended videos :|

[@rogerwebb9600]

Carveco IS ArtCAM Thank you, for watching Please support me on Patreon, subscribe and forward the video on to a friend. Roger Webb ;-)