Deep Freezer Defrost and Bent Door

[@RizN91]

Great video! The only reason this unit is icing up is because there is air getting inside the freezer due to the gasket not sealing around every spot of the cabinet but this can be easily fixed. you can use a hair dryer (or heat gun on low temp) to close the gap, warming the pvc plastic will allow the magnets inside to pull across and seal the fridge, this will also allow the entire door gasket to mold into the correct shape, just make sure you let it cool down afterwards. You can also put something underneath the seal (bluetak or cardboard) to prop it up a few mm to seal the gap(s). Also because you have a screw in door gasket, as soon as you loosen or remove those screws the door looses its flex, you can bend the door as much as you want or need to make it straight while the screws are loosened around the door then when the door is perfect straight - tighten the screws up and the door will stay in that shape. Make sure to put your hand underneath the door as well to make sure its sealed 100% - if you do this, your freezer will never ice up again. I've done this to 1000's of fridges. good luck and if you ever have any questions let me know - always happy to help anyone with fridge problems who wants to fix it themselves.

[@HiddenTreasuresEnt]

Put a book in the bottom door jam and push it and it'll bend the door just enough to close the gap

[@davekovacs8818]

Looks good

[@UpandAtIt]

Thank you!

[@cd1168]

Was about as bad a video as possible.

[@kingnation3398]

You should toss this unit in the recycle bin. No one needs that many appliances