Duramax EGR delete and PCV install

[@MyBestFriendsInn]

The four studs will back out so you don't need to take the harness off. The 5th stud can stay in place as the plenum is slotted.

[@Sandman0760]

THANKS JAMES!!! There isn't any flippin directions for this stuff anywhere!!!

[@jameslee522]

I tried. Lol towards the end i kinda gave up on the video and just wanted it done.

[@tpittowski4895]

Where does the other bracket go? I might have missed where you installed that,. Thanks

[@hackingthematrix1141]

Thanks for sharing pal. God bless

[@stealthcon6975]

would this be the same for an lly

[@natemasterson245]

how did you go about doing the PCv reroute? did you purchase a kit that had a PCv reroute included or did you do a diy solution with a copper fitting like I have seen going around? looking to do this same install. also curious if you threw in check engine codes. and if you are running a tuner of any kind.

[@cantyoufeelthelove]

You still rocking this or have you had issues? Curious about reliability

[@deec3158]

I would recommend not use the cheap delete kits. Better to pay a little more for reliability. Had the same kit and is horrible. Don’t cheap out on this kind of stuff.

[@cantyoufeelthelove]

@@deec3158 thanks. I decided against it. So instead going the efi live route with lb7 up pipe

[@deec3158]

@@cantyoufeelthelove yep that s a good choice man👍🏼

[@rodleypumpkins4174]

People don’t use plates like this guy. If you delete the egr do a full delete. Yes it’s more money. But if you plate off the plates and your up pipe are known to crack. The up pipe mainly. The full kit will include a replacement (lb7) up pipe and full flow passenger side intercooler pipe. Don’t go in twice or maybe three times because the stock y bridge in the motor valley is like 2 or 3 piece. And with the new found power will come apart which is fun. Don’t plate off

[@masonmollman1]

RODley Pumpkins what about people who live in the north when it’s -40, that intake Heater is nice to have

[@romarazumovsky9002]

@@masonmollman1 that heater is meant to reduce emissions during warm up. The block heater is there for a reason.

[@Trashman007]

Just saw your video, very informative. I do have a question though. Who's EGR delete kits did you use? Thanks

[@jameslee522]

+Nathan Harrison cns autoparts. It was a cheap one off ebay.

[@Trashman007]

Thanks

[@michaelshuler5295]

jameslee522 How has CNS held up? I'm thinking about going with them on my lbz

[@TheRealDaveRiddle]

Holy shit bro. thanks for the video.... However you might get checked for Parkinson's Disease. You were shaking like dog shitting a peach pit.

[@jameslee522]

+6669Jarhead the video wasnt planned out. This was the 1st time doing it. And I just recorded bits as I was doing it.

[@papadressing]

is there a gasket on there that would have to be thrown away or reusable for the valves

[@jameslee522]

woolen ominvore on the valves?

[@papadressing]

Yes I'm trying to take mine off and clean it and put it back on but Idk if I can reuse the gaskets or not

[@hootowl6354]

What year is that truck? My LB7 looks nothing like that. It's a 2003, California.

[@derekschmucker1609]

Hoot Owl being that the owner says it's an LBZ it should be an '06 or '07

[@hulk7622]

That's a lbz or lly. Not lb7

[@Maddog19716]

Yeah I figured that out today lmao

[@942doc1]

so whatd you do when you have to pass inspection?

[@DeadorAliveOutdoors]

942doc1 u don't have to pass any inspection if ur County doesn't require it

[@m5paeplow]

On which duramax engine was this performed?

[@jameslee522]

Lbz

[@movingearth3726]

jameslee522 link to what you bought and you go efi ?

[@tiffanysanchez1191]

Did your check engine light come on?

[@quentins5692]

Yes it would. Just flash it. Or tune it. That's works too

[@movingearth3726]

One piece comes right take intake tube off right up to the intake comes out one piece under 10 minutes I swear

[@bobreighnheart5071]

have you had any seal issues since you have installed the delete ?

[@jameslee522]

yes, one of the O-rings blew. I had to replace it.

[@bobreighnheart5071]

are you running a lot of boost pressure?

[@gizmo75000]

Whos egr delete kit did you use?

[@TruckMaster]

Look at this on eBay: www.ebay.com/ulk/itm/221808863960 I did a video on this one $180 EGR Delete Kit Chevy GM Duramax 2006-04/2007 6.6 LBZ w/ High Flow Intake Tube

[@Maddog19716]

Did you get a loud whistle after doing this because I do

[@jameslee522]

+Maddog19716 no. you must have a leak

[@DeadorAliveOutdoors]

Duallymax06 probably o ring

[@stealthcon6975]

Will it throw a code and if so how to delete it

[@sharkson7725]

Stealthcon69 tuner

[@MadDragon189]

What is the purpose so that

[@DesertStorm986]

Kevin Ventura it is to save the engine from the engineers, it is forced obsolescence, and emissions crap, it will destroy the engine

[@sfrcorp]

Camera work is horrible. Got a headache watching it!