GTI Runs Rough Timing Issue Cam Crank Correlation P0016

[@Miauzur]

This is a good video,what causes the spool valve stem to stick out when it is bad?All other youtube videos say to just replace it,but what cause it to go bad /stick out?

[@deamonmachine]

not sure why it does that, but I had one with it sticking out, I disassembled the spool valve (popped out the spring on the top that keeps it from falling out) and took it apart, pressed in the button using a vice and it worked fine. Again, not sure WHY it pushes out however maybe it's fixable.

[@AliAZEEMI-ey9ns]

My car does the same, so error code cam shaft position sensor is the timing chain? My car only has 120k kms

[@jjnguyen8809]

would that p0016 cause a mechanical malfunction on the HPFP?

[@Searcher-123]

what is the name of the magnetic plunger part, also when you were testing it what voltage were you feeding it, 12V ?

[@deamonmachine]

That part is the magnetic adjuster and it pushes on the oil control spool valve. yeah, just a power probe feeding it 12v to make sure it .. magnets.

[@shark180]

Wait wait wait I follow you on Twitch but just learned that you have a KZbin channel.

[@ericabertagnoli5469]

I have this code but sadly looks like I need a new timing chain

[@tedjohnson64]

Very interesting video! When you supported the engine with the floor jack, what was the jack pad pressing against, the oil pan? Also, what was it that caused the plunger to be so hard to remove from the oil control valve? Was it metal particles from the metal cam bridge screen? Old enamel or sludge from cheap oil? Or..? Thanks in advance!

[@deamonmachine]

Yeah, floor jack, block of wood and the corner of the oil pan (an area that has the most support with corners and wall, don't go for the middle of the pan, that will collapse). Corners save the world!

[@tedjohnson64]

@@deamonmachine Aha, good tip about using the corner of the oil pan! No concerns about squishing out the oil pan gasket though? BTW, your haircut @1:58 is awesome!

[@gstacks510]

When can I get the special oil spool valve tool ?

[@deamonmachine]

In a 2.0L CCTA Timing Kit, it's required to remove the timing chains, you can find an.. inexpensive one on amazon.

[@gstacks510]

@deamonmachine not talking about the timing chain... I'm talking about the oil control valve you removed and cleaned out. Where do you get that specific one ?' I already ordered 2 off Amazon and they didn't work... Thanks again.

[@buffalotroll2358]

Did it throw any other codes

[@Maheralwan]

one month too late deamonmachine it took me a week to diagnose that valve. on mine the pin was popped out btw so that's another way it fails

[@aliennemesis0663]

Where u locates

[@deamonmachine]

Far away in the usa

[@lapuntadeoro]

I have the 1.8 tfsi and it has misfire 0 error codes in the vcds channel 91 work cycle 45% and in the settings it shows 35 kw specified and 35 kw current and it lacks a lot of power

[@robloxperalta9646]

Good video