How To Remove Center Console & Ignition Switch Module SAAB 9-3 2003-2011

If you want to remove center console & ignition switch module, this video will help.

[@pauleta6310]

Excellent details and video. Great job my friend

[@saabmastertech5852]

Thank you very much! 🙂👍

[@Bob-bs3ev]

Thank you. Your video is a great help.

[@saabmastertech5852]

Glad it was helpful!

[@darenwilkieson6676]

Enjoying the videos m8...thankyou...👍

[@saabmastertech5852]

Glad you like them! 👍

[@patrickhallogy]

Thank you very much. Well done.

[@saabmastertech5852]

You are welcome!👍

[@ginawilliams2204]

Thank you

[@saabmastertech5852]

You're welcome. 🙂👍

[@gordondolan6443]

Very good. Mine is 2002 but must be similar. But why did you not use WD40 on one rusted/seized screw?

[@gordondolan6443]

Forgot to say you wasted no time on irrelevant things that so many other video makers do. Will watch your other vids! 😊

[@saabmastertech5852]

Thanks!

[@alindorindicu3732]

Grazie mile!!!

[@saabmastertech5852]

You are welcome!🙂👍

[@alindorindicu3732]

@@saabmastertech5852 I managed to take out the console and your video was much appreciated. My problem is the hand brake lever is stuck in the upper position. But still, on my 2003 SS, there are 2 more black screws on each side of the console. These screws are accessible from the sides facing the sits. I'm not sure if your video shows them.

[@saabmastertech5852]

You are right. I rewatched my video. It seems like, the 2 screws were missing in the car. Grazie!👍

[@debbiedreg6614]

Can you do a refurb ism video please

[@fredericd2670]

Please could you tell me where is the separation of hand break s cable ? My hand break doesn't work on the right wheel . I don't know if it's under the car or under the central console. thank you

[@saabmastertech5852]

You can watch the video on "How To Remove The Handbrake Assembly". Disconnect the handbrake cable from inside. Remove the rear seat & lift up the carpet. Cut the cable tie holding the handbrake cable. Pull out the handbrake cable from outside. Both cables are identical and separate from each other.

[@meatrackz]

Is this what’s needs to changed if you have a immobilizer failure message and car won’t start?

[@saabmastertech5852]

Try another Key Fob, if you have one. Make sure the car battery, is in good condition & connections are tight. Before replacing the ISM.