Jeep Grand Cherokee Radiator Replacement! 3.6L V6 WK2 (2014-2022)

Here is how to replace the radiator on a 2014 Jeep Grand Cherokee with a 3.6L V6. I went with the front bumper removal method. Linked video on that.

[@miamidolfan19]

Hey man just wanna shout out my HUGE thanks for your video. My gfs 2014 jeep GC was leaking coolant and after replacing the thermostat and upper hose I finally saw the leak in the radiator. Same exact spot as yours. Ended up tackling the water pump while I had it all removed but I had your video up following step by step and it was a godsend. You have another very grateful viewer! Was my first time doing this and you made it easy. Cheers!

[@LJsGarage]

Great to hear! and happy you crushed it and saved 1k bucks haha

[@24kproductions24]

Thanks for the detailed and simple DIY video. My first time changing a radiator and I was able to do it in two hours with the help of your video. I had a problem with bleeding it at first but I eventually got it. Again thank you 🙏🏾

[@LJsGarage]

Awesome good stuff! and yeah that bleeding can be sketch when its steaming lol

[@natiboyhd9229]

Thank you for making this video I just replace mines with out taking the bumper off and it wasn’t bad at all it did start raining so I had to stop but by than I was putting everything back together

[@LJsGarage]

Well done glad you got through it!

[@theusedcaradventure9094]

Super helpful. I have a 15 eco diesel that decided to have an oil cooler fail and will need to remove the radiator for cleaning or replace.

[@LJsGarage]

Glad it helped!

[@keepitreal936]

I replaced my radiator a 1 1/2 yrs ago now on my 2015 Jeep Grand Cherokee 3.6l V6. I avoided taking the bumper off which saves some time for sure. I watched a couple of videos which showed how to without removing it. It is quite the job for one person. One step frustrated me putting the radiator back in its place. It all hinged on the angle that I had it to snap back into place. After almost an hour frustrated, I put it on a slight angle and it snapped back into place. Not for the novice DIYer

[@LJsGarage]

No doubt it's a tough job. I think the 30 min to take off the bumper made this easier for me personally but I can see if it's someones first time removing it that adds another 1.5hrs like you said!

[@chrised1115]

Removing the bumper is the easiest part of the job. I rather spend 10 minutes taking it off then spend a half hour fighting around it. To each their own I guess.

[@gtsteve9481]

Awesome…. Thank you Sir! Didn’t know where to start. Brilliant well explained, well shot & informative video. Taking the bumper off the BIG secret. Thank you 🩷👍👍

[@LJsGarage]

More than welcome, good luck!

[@Acinc-lr2jp]

I just did this. Just a tip I didn’t need remove the entire top molding only half and used a bungee cord to hang it on the hood connection.

[@LJsGarage]

Thanks for passing that on for others!

[@joannephilip9253]

Perfect, thank you 😊 that was so informative and lets me know what to tell the mechanic.

[@LJsGarage]

Glad it was helpful!

[@bolognawilson3252]

Thank you never really touch a jeep before ❤ got it done 🎉

[@LJsGarage]

Happy to help!

[@wilder211]

Finally a quality video on this. Thanks LJ

[@LJsGarage]

No problem! Good luck

[@pmwahlberg]

Just got done replacing my radiator. Thanks for the great video!

[@LJsGarage]

No problem! 👍

[@kh5063]

Love your calm voice

[@LJsGarage]

Much appreciated my friend 😁

[@BenWade-yw7it]

Well done brother! This video made this job super easy for me. You are super good at making the video and talking through the steps. I really appreciate you man. Keep up the good work!

[@LJsGarage]

I appreciate that! comment like these keep me going

[@DBSSEAN]

Couldn’t find a better video for this man, me and my DURANGO thanks you🔥👌🏼

[@LJsGarage]

My pleasure!

[@theguyjt7921]

Great video, time to do the wife's. Wanted to get a quick rundown. One recommendation, is get yourself a bleeder funnel. Makes bleeding anything super easy and don't cost all that much.

[@LJsGarage]

Agree on the funnel! thanks for stopping by.

[@BaaBaaBlackJeep]

I was looking for the part number you used - soooo many diff radiators available online it seems. Thanks in advance...

[@LJsGarage]

Glad I could help and yeah it was a mess and people say the HD vs non-HD isnt a big deal but I couldnt ignore it

[@jessicapalamara78]

Well thought out video. Thank you very much.

[@LJsGarage]

Appreciate the feedback :)

[@coexist1018]

Great detailed video, I'm gonna subscribe to your Jeep content

[@LJsGarage]

Awesome thank you! Hopefully not too much more haha other than the basics

[@coexist1018]

@@LJsGarage I'm actually from a Jeep dealership but non certified, I removed the bumper for the job

[@PhilSoussanOfficial]

Great video! No nonsense, to the point, and you have a great way of explaining what you are doing! Thank you. Is this pretty much the same for the 5.7 Hemi V8 ?

[@LJsGarage]

Glad it was helpful! And essentially the same

[@thealleyestkat__trifelyfe6386]

I did it in a day but didn’t bleed air out the system .can I simply just bleed the air out now like you demonstrated?

[@LJsGarage]

Way to get after it, and yup sure can!

[@willpanzino6847]

Great video. Thanks man!

[@LJsGarage]

Glad you liked it!

[@dylangillis8665]

Wish me luck going to use this video to replace mine

[@LJsGarage]

You got this!

[@lisanorm2458]

Hi, i have a question, can i also swap out the condenser while at it, other videos show you have to pull bumper off ( wrote this as you were saying don't need to remove) but i don't want to do that,i have a bull bar and its also got headlight washers as well as being a diesel, its too much work having to remove all the front part, so i'm hoping i can change the condenser out after the radiator.. sorry if that made no sense. Nice vid thanks

[@LJsGarage]

I did both at the same time so def doable

[@lisanorm2458]

@@LJsGarage Yeah i did it, a bit fiddly but very doable, an extra clip for the inter cooler and extra piping to get off, thanks from Australia, Cheers Mate :)

[@pattycarljackson]

I just got mine done and the water pump was so expensive and I kinda wish I did it myself.

[@LJsGarage]

I can imagine oof. I did think to do that while I was in here lol hope it lasts

[@benrodriques]

What did it cost?

[@pattycarljackson]

@@benrodriques I don’t remember anymore

[@RIKOHDOUBLEOG]

Oil pump next and rocker arms and electronic power steering unit

[@LJsGarage]

Oh man those are no fun 😬

[@orlandomazo1274]

WHAT A GREAT DIY VIDEO. DEALER CHARGING $3,500 for this repair

[@LJsGarage]

Ouch! Hopefully you can get it done

[@FD-dh2fu]

Great video. What’s the major difference between heavy duty and non heavy duty? Thx.

[@LJsGarage]

From what I could see just a few more ounces of coolant in the radiator at a time like 10% so I just took the time to find a HD but if you're not towing it wouldn't even matter

[@thisisyourtransmission]

How many hours did this take you to do from beginning to end?

[@LJsGarage]

Took me about 3.5 hours and another .5 hr to bleed and fill

[@nomannerssrt]

Gotta get better .. shouldn’t take no longer then an hr

[@DBSSEAN]

Where’d you get the part ? And can you drop a link?

[@LJsGarage]

Autozone If I recall Duralast Radiator B13200 and there is an SD/HD so whichever

[@DBSSEAN]

Yeah I bought it and turns out it doesn’t fit the 2015 dodge Durango. Gutted out the entire old one and couldn’t even get it replaced. Even tho autozone said it was the exact fit🤦🏼‍♂️🤦🏼‍♂️

[@Turbo-x2]

Thanks g

[@LJsGarage]

Anytime man

[@Acinc-lr2jp]

What the diameter of the plastic clips.

[@andrewdaugherty6943]

How many gallon 50/50 or concentrated

[@LJsGarage]

I believe from empty it holds about 14 quarts

[@andrewdaugherty6943]

Thanks I'm switching from that dexcool stuff and going to prestone

[@namikbagrov7016]

Не показал как снять трубку масла коробки

[@LJsGarage]

Sorry friend

[@Sire-hf2xz]

What coolant is best recommend for this car ?

[@LJsGarage]

Mopar is what I stick with not too much more than the AutoZone stuff

[@theguyjt7921]

Zerex G05 is the same as the Mopar but clear instead of pink.

[@mralapenosarespicy]

I got charged 5.5 hours of labor for this (they changed the thermostat too) somebody be honest how much did I get over charged lol

[@LJsGarage]

Not too bad honestly. Maybe an hour over what it takes so 100-150 over

[@shortbusautorepair]

Calls for 3.8 hours.

[@coexist1018]

Some places change the thermostat and hose along with the radiator to cover there behinds

[@miamidolfan19]

That's about right. I did the radiator fairly easily, would have been about 5-6 hours but I did the water pump too which took another few hours, hell just cleaning the mounting surface was an hour of scrubbing away with a scouring pad. 2ith the right tools it would have been quicker for sure.

[@jeremygrady1107]

How do I tag LJs Garage? The engine antifreeze/coolant SHOULD NOT BE RED!!! That is the wrong antifreeze/coolant for the vehicle. He needs to be using a HOAT Antifreeze/Coolant which is either orange or yellow. A red coolant is most likely OAT which is not the same as HOAT.

[@LJsGarage]

I used the Mopar OEM stuff so im not sure what you are referring to so hopefully I used the right stuff. Thanks for caring to pass on that though!

[@bh1368]

​@@LJsGarageyes you used the correct coolant which is the OAT coolant, he's referring to the HOAT coolant which was used in model year 2011-2013. He doesn't know what he's talking about, you're all good dude. Thanks for the awesome video, I'm about to tackle this tomorrow.

[@Nards_1997]

Pretty easy job just long and tedious

[@coreychillis9754]

If you don't wanna pay $550

[@LJsGarage]

Yeah agreed!

[@Sire-hf2xz]

@@coreychillis97541500 for me