MT07 front brake pads replacement

[@hstefan]

I will be doing soon a brake pad replacement on my friend's Tracer 700 which has very similar brake setup to the MT 07. I was looking for a brake job video but instead stumbled onto this. I now know exactly what to do. I thoroughly enjoyed this. Thank you!

[@stumpedtree4204]

Bro went the extra mile here! This is what a bike shop won’t do. Respect

[@stumpedtree4204]

Bit of grease back on the pistons before you push them in to fit new pads does no harm but this is professional!

[@lillashehata3723]

Never thought I would find a video of a brake pad change satisfying 😂👍

[@MT09spDARDY]

Loved how simply made it!! What torque setting did you use in NM

[@abdotaher17]

Nice video, how many Nm did u fasten it with?

[@robcall5182]

no messing about, good video, and shows exactly what to do, thanks, next video? how to stop your shoes SQUEEKY on the floor.

[@artyom188mph]

You should hold front brakes lever tight when you tightening up brakes to let pads lining correctly

[@zenden8030]

how many ft lbs did you tighten the bolts to?

[@djkellyflavour5481]

Thanks for the video. Exhaust sounds good. Link please

[@SiliconDrifter]

How many ft lbs?

[@eyeanblue8374]

Nice! How about the rear brake change lol. Thanks for the video.

[@4DXTProductions]

What stand is that?

[@mindvisionstudio7358]

Please can you link the red stand of your bike i want to buy same .. regards

[@CarlosGarcia-lx6qn]

Hello its and Abba stand, it's pretty useful 👍

[@rickote]

This is like moto asmr

[@zireael666]

This was perfect! thanks.

[@ST3FNVSK1]

My front wheel doesnt spin as it should,it spins but doesnt make a whole circle it like does half circle then stops,is it possible that the problem is caused by the brake pads?

[@CarlosGarcia-lx6qn]

Hello, it could be the brake pistons binding or your bearings are shot.

[@ST3FNVSK1]

@@CarlosGarcia-lx6qn the axle has nothing to do with it,right?

[@gregorylagrange]

@@ST3FNVSK1 Front may just have what's called a bearing spacer. Do you hear any noise from the front when it's rotating or when you're riding like a BB spinning around inside a can? There could also be some warping of the brake rotors if you have a lot of miles on them. But you should keep in mind that a motorcycle wheel won't spin freely from your hand spinning like you would expect a bicycle wheel to do. The loads and the lubricants are different for a motorcycle wheel and it's bearings.

[@ST3FNVSK1]

@@gregorylagrange i can hear the exact same noise from my rear tire as wel l but the rear spins smoothly and stops when it should,i have a feeling that the front loosens up a bit when motorcycle is started and sit on,brakes and everything else work fine idk if there is anything wrong with the front wheel or not but i dont think it should spin that hard no matter if the bike is started or not,btw during riding u can’t feel anything stopping the fromt wheel so.. but after droping it from wheelie u hear like a little scratch when the front wheel goes down idk if thats normal or not xd

[@ST3FNVSK1]

@@gregorylagrange thanks for answering xD

[@ed4778]

Excelente!!!! 👏👏👏👏👏

[@stevepurves635]

You should put a light smear of copper grease on the back of the pads before inserting them.