Mustang Total Control Products Subframe Connector System/Driveshaft Loop 1965-1970 Installation

Bill shows you how to install a Total Control Products Subframe Connector System Package With Driveshaft Loop on your 1965-1970 Coupe or Fastback Mustang.
Purchase Product Here:
www.cjponyparts.com/total-con...
Includes a pair of weld-on subframe connectors, a bolt-on center support and a bolt-on driveshaft safety loop!
Tying the subframe connectors together is a bolt-on center support constructed from 1-5/8" x .134" round tubing. This diagonal cross brace is held on with grade 8 hardware. Four 7 gauge mounts are slotted to allow for chassis variances. A shim set is included to achieve a perfect fit every time.
Check out more Mustang RestoMod Chassis Stiffening from CJ's here:
www.cjponyparts.com/mustang-re...
Check out more Total Control Products from CJ's here:
www.cjponyparts.com/total-cont...
Subscribe to CJ Pony Parts on KZbin here:
kzbin.info_c...

[@springpinn711]

You should have the car with its suspension fully loaded when you weld in order to have the proper chassis alignment. Love these videos though has helped me a bunch on my 66 project.

[@hughphillips67Mustang]

The crossmember brace with help tremendously. I would want that and not the shaft loop. Every Mustang should have that crossmember support.

[@JoDaddysGarage]

NIce video. Good info.

[@RobertKohut]

Nice, well made kit!! Almost need a "prettier" driveshaft now...LOL...LOL.

[@racinford1]

be back on the road in 3 hours. LOL

[@robo2901]

If you have a gear vendors gear drive will the driveshaft loop be left off since the tail housing of the c4 transmission is longer?

[@XA351GT]

I'm surprised you didn't use a weld through primer. Every place there is bare metal touching it will eventually rust through the condensation between the panels. Especially since this is under the car where it will see more moisture than most places.

[@mystang0304]

I want to see what the exhaust looks like on yalls car, this blue 70. I got this cross brace but dont run it cause the exhaust issue.

[@unccred]

Ho much weight is this adding?

[@Zerogivengarage]

+Zach Huneycutt 26 lbs

[@korbun3235]

Zach Huneycutt it is worth it

[@mystang0304]

No comment. Lol

[@raaah]

just replace your lead battery with lithium one and that should compensate

[@TMD4343]

Bolts should have at least two threads showing or the self locking nuts wont hold properly

[@cgc]

The entire underside of the car is black....hey, lets use some red paint to cover where we ground down the frame. smh.

[@coreytilton7688]

its red primer. for whatever reason these guys in the cjpony videos have a can or two of red primer that they use for everything. they go over it all with black gloss after normally. maybe its so you can better see it for the install videos?