Push Button Start Any Vehicle

[@paulhager1281]

My dad this 25 years ago to my nissian 240sx...newer cars you would lock up the engine antitheft and such

[@TLL999]

After 3 mos of my 98 crown vic not starting after replacing everything , the only way it starts was with the screwdriver jump... just need to bypass ignition to drive it to mechanic for a diagnosis. Thank you ! No power to the solenoid... banging our heads against the bumper begging it to start not working. (still have sense of humor)

[@real2real726]

What gauge wire did you use I have a 85 Ford bronco and I wired it it starts up but shuts down should I use a bigger gauge wire I used 14

[@officialWWM]

That has nothing to do with the wire!

[@tyeprosser2971]

@real2real726 did you ever get it figured out I'm trying to do it on my 89 bronco and I think I'm facing the same issue

[@mountainmadefarm]

Super helpful, thank you!

[@richardmckinnon6749]

There is a little tab on the back of the original ignition cylinder. I’ll be willing to bet that the tab that turns the actual ignition switch behind it is broken off … I’ve changed out a few of them with those Chrysler ignitions.

[@pancakeairsoft7145]

Need this for my neon race car thank you

[@nextgamebud8342]

No dodge neon is a race car 😆😆😆

[@NicoleFry-ds7uh]

Please help I have a 07 Saab 97x 42i 6cyld my ignition switch harness was cut so I have 12 wires that I don't know how to wire up w a push start an toggle switches

[@shutupanddoityourself]

www.saabcentral.com/threads/ignition-switch-wiring.748403/

[@redpig1120]

Don’t need a ground..the starter is your ground

[@certifieddtm4631]

Where’s the diagram as to what wire goes where

[@adamkaminski351]

could the wire that goes to the starter just be spliced into the starter wire on the ignition switch harness?

[@squarebody4152]

That’s what I was thinking that way it’s fused right

[@shutupanddoityourself]

It probably could. I had to install a push button start out of necessity because the aftermarket alarm shorted and removed connection from the ignition module. I bypassed all the wiring because it was bad. If you do not have electrical issues, tapping into the starter wire would be better.

[@Legendarypeople2024]

Just take the old security system out. Should fix your problem

[@shutupanddoityourself]

I will eventually. I am holding off as I am afraid that will open another can of worms.

[@luvdady]

@J Hemphill yeah especially with the brain box getting cooked and your done

[@ricanbrave]

"SHOULD"...

[@jacobdill897]

More than likely your starter solenoid went bad, easier fix than all this .

[@officialWWM]

Nope. If it was the starter solenoid, this wouldn’t work. It’s the actuator in the ignition switch. They are a known failure point.

[@emptysoul5057]

Most likely neutral safety switch

[@AtwoodBoxing]

Igniting switch

[@Spankdatdank]

Congratulations now you have shown thief’s how to get people’s rides 😂

[@carlosherrera8541]

I’m stealing my car out from my driveway for this weekend till I get my ignition shipped 😂

[@RidingWithWill]

False you gotta still have the key in order to start it