Replacing the engine on a Kawasaki KLE500 Part 1

Check out the channel updates on:
Instagram: / restorationvalve
Tiktok: / restoration_valve
Well, who would have thought that the engine wouldn't last long in the freshly restored Kawasaki KLE500?
In this video, we're taking apart the KLE and preparing the new engine for the engine installation.
Check out the channel updates on:
Instagram: / restorationvalve
Tiktok: / restoration_valve
Check out the eBay store for the spare parts from the projects: www.ebay.com/u...

[@franklyThor]

My 1993 engine seized this week. Very helpful video. Thanks for sharing. Greetings from Norway.

[@pedrosalvador8894]

Gracias por mostrar tu mecanica.

[@bravoleo4025]

hi, what happens with previous engine, where is a problem, why you changed an engine? i saw your announcement in ss.ka is it reliable engine at all?

[@restorationvalve]

The first engine lost oil pressure and I don’t have time to explore the reason, because I was going to Denmark with it. The new engine runs like a dream, have done several thousand km on it already

[@guyonacub4335]

So is the E5 engine exactly the same Or are there mods to do Thanks for a great video

[@ThunderMan88]

the same but you need to check the wiring loom and something else that I forgot. Check the forums

[@tree-service]

Why turn off a system of afterburning of fuel?

[@restorationvalve]

This Kawasaki doesn’t have a EGR system, the block of plates are from the factory. I don’t really see a reason for me to order a used EGR valve and then try to retrofit it on this bike.

[@nileus]

Just in case: er engine cap has a two pipes goes onto the filter box. This is not egr, just crankcase gas pipe. If you close this caps on top of the head all pressure will go from the breather onto the filter box, but with oil

[@vietz_artclassic]

Timing point T is the position of the piston above the left or right, sir? Is it the same as the en400 engine 🙏

[@restorationvalve]

“T” on the rotor means the top dead center for piston nr.2. To set the timing correctly, you need to set the crankshaft to “C”. That puts it on TDC for the first cylinder.

[@vietz_artclassic]

Ok, thank you, so timing point C is for piston nr.1 on the left side

[@hansheld8782]

Hi Bro, nice video, thx for it. One question: What is the hight of the wooden block for the motor? Thx a lot. Hans

[@restorationvalve]

Hi, I haven’t measured that block, I assume that it’s 200-300mm in height

[@tree-service]

In the notes

[@unokarpa4405]

за сколько ты купил запасной двигатель?

[@RR-eg6gx]

150-300 pounds in uk