Saito FG-60 R3 time at 30 degrees on all cylinders before TDC

[@rodneykreutzer1]

One small problem, you are checking the timing when triggering the sensor, the spark does not occur until the magnet passes the hall sensor, you are not at 30 degrees at all. If you don’t believe me put a plug in the wire.

[@173shatta]

rodneykreutzer1 We work with RCEXL on this software, so we know how it works

[@roberthatt4320]

The video is correct. For single fire ignitions, ie without an indexing magnet, Using the rcexl timing device, it is as the magnet LEAVES the sensor. For multi cylinders , ie. with an indexing magnet, it is timed, Using the rcexl timing device, as the magnet APPROACHES the pick up sensor. If you don’t believe it, check out rcexl instructions !

[@Jeffryzable]

Have you seen that this change in timing evens out the temperature differences between the cylinders?

[@173shatta]

Jeffryzable yes this set up improve the cylinder temperature issues

[@jean-marcoberle5621]

Could you make a video with an improved engine running ?

[@173shatta]

Jean-Marc Oberle yes we will make a video with it running

[@izudindin2679]

helo sir,can u share video for assambly saito fg33r3…i reassambly but forget marking for timing set..so i dont know how to set..plz help me sir..tqvm

[@frank-vq4mx]

I have the FG-60 and have bench run it for over a hour. I followed the instructions to the letter. I have temperature sensors on all cylinders and find that number 3 cylinder keeps dropping off. Is there anyway I can make these changes without having to send the engine to you ?

[@173shatta]

Hi Yes you can buy the kits and do it yourself

[@harisgavanas7874]

Why you measure the timing with the same magnet??? I think you should turn and check all the magnets of the hub....

[@173shatta]

We have use 3 different magnets when we check the timing

[@roberthatt4320]

Look at the position of the sensor pick up when each cylinder is being checked and you will see that all 3 magnets are being used for their respective cylinders. It would be impossible to check the timing on all 3 cylinders with the same hub magnet !!!!

[@WayneCook306]

Pittey you do not answer your emails..

[@173shatta]

Wayne Cook We have all reply to your email,

[@WayneCook306]

@@173shatta Have not seen any reply's Anywhere

[@173shatta]

Wayne Cook we have replied on the same day and also send you the invoice have a look in your spam or junk folder on the day that you email us

[@WayneCook306]

@@173shatta Hi There, I have looked in my Spam and junk nothing what so ever are you sending to the correct address or are they coming back to you??

[@173shatta]

@@WayneCook306 OK what is your email?