SPEED TIP (Glued Side Walls) How to Go FASTER - Spencer Rivkin

[@MaxNormal754]

Thanks for all of the great tips. I'm old enough to remember when the fast guys weren't very helpful.

[@mattwilbert3305]

Would you be able to make a video going through your selection of tires for 1/8 buggy? How you decide the compound and tire you pick for the conditions.

[@DoubleClutchProductions]

Different world with youtube, back in the day the oldschool dudes kept the secrects locked away like launch codes for nukes. Thanks for the tips

[@DiscGolfAU]

Good tip I will give this a try. Before I do can I check with you if you glue both the outside and inside walls with the method you have shown us?

[@andytalllurch]

Watching tour thread trying to get backbinto running vars after 20 years. Do you glue both sides or just the outside? Sorry if it is a stupid question.

[@lawnmowerdave]

May try this with an older set of short course tires since I feel traction rolling due to tire fold/body roll is most apparent in that class.

[@GabrielChua75]

Thanks for the video Spencer! Will doing this help for 2wd astro front tires like Cut Stagger too?

[@chucksmith155]

Great tip Spencer

[@teamcamel1755]

Thanks for the tip 👍😀

[@caseybarber5683]

what about glue on the edge of the tread above lettering to make the car push a little :D

[@zachf9853]

Could you get a similar benefit by running VTR/60mm front wheels which have lower side walls?

[@johnmyall5548]

Used to do this a lot when racing on astroturf, but for some reason they banned it a couple of years back from the UK nationals and regionals🤷‍♂️

[@justinmoon4350]

Speed tip drive faster lol 😆😂. Great video spencer 👍👍

[@Kaylem13]

Mmm, I've been almost there then with my messy tyre gluing....... I must be pro too. Lol. Cheers Spencer.

[@mikeblythe4398]

Great vid, Spencer. Gunna try this out tomorrow at HA. 🤙

[@shaun4298]

Just take it easy man.

[@mikeblythe4398]

@@shaun4298 Hi! I'm Mike... I dont think we've met. Hehe

[@wildcardjoker]

Would this work on oval carpet. Race slash street stock on rpm revolvers and proline primes

[@Ledsrule1]

Where the side walls already glued in your video?

[@chaddonnelly1750]

New FT thin glue ?

[@rodcaseracing3376]

Does this apply for carpet the same ?

[@davidford6147]

Hey Spencer how Do I fix the white residue on tyres without ruining tyre

[@masonherrick04]

Not sure if you’ve found an answer on this, but if you get a heat gun and run it over the tire it will get rid of it 👍

[@LuisClement]

What about 1/8 scale buggy?

[@teamcrc1]

After 1 run it seams like the glue cracks and goes away? Do you re apply every run?

[@Ledsrule1]

Had the same problem now I use a glue activator. The activator I’m using is call Mitreapel awesome The cure time is 1 minute and it ready to race. It stopped the cracking

[@nonexegimonumentum8583]

Clay or carpet?