How to Replace Front Lower Ball Joint 2001-2007 Toyota Highlander

[@TRQ]

√ Watch the Video √ Buy The Part at 1A Auto 1aau.to/m/Shop-TRQ-Parts √ Do it Yourself √ Save Money

[@PrimitiveOverland]

I like this channel a lot.

[@nathanialkeeter5028]

Thanks for the very straightforward and informational video

[@notme22]

I’ve never seen a 1AAuto/ TRQ video that was so bad before. There was no reason to take the axel out unless the ball joint stud nut wouldn’t come off. Never use an impact to tighten the ball joint stud or axel nut and always use a new axel nut and clean up the threads and degrease the axel before you reinstall into the hub. Also, the wheel bearing was bad. Could tell because that thin metal shroud inside the knuckle had walked out a bit.

[@Amarodane24]

How did you flatten the ball joint when installing it? My new ball joint isn’t like that

[@christianfiguroa7147]

Nice View. Why did you say 17mms at the start then 18s?

[@ronhutchinson3479]

How are you leveraging the control arm down? I can't see how to move it down, It looks easy, but I don't know where to place my pry bar Thanks

[@RocketBurn11]

How do you know if you have a bad ball joint?

[@Amarodane24]

What size of pickle fork did you use? I have one but it’s too small