2001 Silverado Cruise Control Not Working with LED brake lights

I have a 2001 Silverado where LED brake lights were placed on it. Found out LEDs in the center high mounted stop light (CHMSL) "third brake light" is what cause my cruise control not to work.
I couldn't find anything on forums and nothing that explicitly showed you the fix it. I did find a few on it you had a camper shell or trailer hookup but nothing on the cruise not working.
I bought the following resistor to place in the brake light wire to and it fixed my issue. Cruise control now works.
50W resistor kit for fixing the issue.
amzn.to/3PjfrDt

[@russelldb1593]

So spice the 6ohm resistor to the ground (black) wire to the positive brake light (red) ... Right?

[@HangryAngler]

Correct. you are just creating another load on circuit to draw more current. Essentially negating the fact you put in a LED and drawing the extra current. Just make sure one you use mall mounting screws. Too long and they will go through your headliner. Also, make sure you put the wires on the other side. That joker gets hot.

[@russelldb1593]

Is this still working? No problems? Thanks for the video

[@HangryAngler]

Yes sir, no problems.

[@russelldb1593]

Mine didn't... Everything worked fine until the 3rd break light, I'll figure it out one day. Checked my fuze it's all good, @@HangryAngler

[@fintansky9369]

@@HangryAnglerwas the problem intermittent?

[@HangryAngler]

@@fintansky9369 No mine was all the time. I could put the old non-led light back in and the cruise control would work. THe LED needs a resistor to work. Just needs to draw more current.

[@t2automotive682]

Is it like a resistor would be needed on ALL break lights if they are LED for the cruise to work? Not getting a fast flash when signaling.