xtool Conveyor Review - Do not buy

[@brandonbevan6426]

I know it’s been a few months but is there anyway to separate the two halves in order to give it more height? Obviously you would need to build an extra riser in order for this to work so you don’t get smoke in your shop but is it possible

[@everygooddaydesigns]

@@brandonbevan6426 the part that pulls the wood through is a set depth from what I've seen however i can double check that. It would be nice, even if I can I would be worried it may mess with the calibration for angle and rate it pulls wood through

[@brandonbevan6426]

I agree I think the design of this is crap they should have put the rollers on the outside of the conveyor so if you have stuff passing through the rollers wouldn’t effect it!! This is only for flat stock which I’m sure for most is useless

[@everygooddaydesigns]

@@brandonbevan6426 yeah, I had plans and bought the bundle. Unfortunetly that caused me to skip over the P2. I probably wouldve gone with that for the bigger work area

[@novarestoration9023]

I’ll buy it off you how much do you want for it?

[@everygooddaydesigns]

@@novarestoration9023 I would actually like to sell it, might consider that eventually

[@Eyez313]

So do not buy, because you didn't read the item specs....got it

[@everygooddaydesigns]

@@Eyez313 yeah sure or because it doesnt have really any real value. If you only plan on engraving half inch boards good for you. If my advice doesnt resonate then get it. Thanks for the input

[@Eyez313]

@@everygooddaydesigns currently in cart

[@everygooddaydesigns]

​@@Eyez313 okay lolol, its your money. Best of luck brother

[@Abbysatticcreations]

If you add tabs the stuff won’t drop through.

[@Abbysatticcreations]

Also I agree definitely can’t put thicker wood. Would have been great if we could.

[@thewinstons9609]

Its definitely a waste of money smh

[@everygooddaydesigns]

@@thewinstons9609 yeah, they were scammin when they made that lol.

[@thewinstons9609]

@@everygooddaydesigns 600 plus down the drain the tab system is to complex to figure out and no videos to figure it out smh

[@everygooddaydesigns]

@@thewinstons9609 yeah, they definently didnt give this one as much thought as they did other components. Lol