You have the USB male that thinking out goes to the USB C on the bike then you have USB A female and then the USB C female is power input if it’s power input can it charge and all?

over 100 years and they still can't get it right...they wan't you to use zipties to fix this. You pay a premium price for the HD brand and these issues are careless...there is no accountability at HD

Get the HD app, register your bike, 😮and you will get any recall notices. Plus, on the new infotainment, you odometer is updated.

Thanks for another great video! I had the recall done last Wednesday (dealer did not even know about it yet). And even though I installed the Trashin' skid plate two months ago, there was already some slight rubbing visible on the harness. So apart from the extra zip tie they also added some extra wiring tube around the wiring part that was touching the engine case. No troubles yet, so I think problem fixed. A small issue but with huge risks....

Sounds like a 30-40K pain in the ass.

Man you are very informative thank you so much . Rob

Bro, want to give you an update on the siren install in my 2024 Street glide. I purchased the Siren 11 with the radio connection to a mobile pager. The siren install went very well and as you suggested there is a planned spot behind the battery to house this. Fits very nice and tight. There is a connector available very close to this spot. I was thus able to connect the siren fit neatly in the spot and ran the antenna over to the frame where it fitted very neatly. On point:: the battery tray that sits on top of the battery has two plastic clips that fit under the ledge on the rear fender. The left clip needs to be removed as the siren body will block it refitting. After removal of such no problem it all went back together. BTW as I was under the hood so to speak, I changed out the OEM BATTERY WITH A TITAN 8 LITHIUM TITANIUM OXIDE. XS Manufacturer. This is the RSV-S5-30Q 12V BCI Group 30/30L, Lithium Titanate Powersports Battery Reserve Modules - Designed for Peak Capacity This Titan8 Series Lithium Titanate Oxide (LTO) series uses a cell that is designed to maximize capacity and deep cycling abilities. They have double the amount of storage energy as the PWR version but only half of the instant discharge energy 1,355 amps of the PWR. This gives it double the capacity rating, but half of the wattage rating. The CCA is THUS 600 and it has significantly more reserve than the OEM battery. Starts like a trooper.My hand held remote control synced up and works great.

That’s complete and utter design rubbish… They should send techs to the new buyers and do these jobs on site…

Is the fairings all the same and same dimensions as far as the road glide, road glide CVO and CVO ST?

My 23.5 RG CVO is rubbing in the exact same place and zip tied just like yours. I'll be correcting that myself this weekend.

They have many different ones on eBay that are not harley oem but will fit. They are under $30 and look really good.

Hi, how can I tell if the dealer updated my 23.5?

First time viewer. Love the low key, factual info. Subscribed

I keep having to rewind because I can't stay awake

thanks for the video. I am on the recall notice. I did read the article in a major news outlet saying that out of 40k bikes they have had 9 line rubs triggering the recall. NO accidents based on this recall! Just planning to go out to the Arkansas Ozarks for a few days in two weeks and based on the odds I do not see a reason to change my plans based on this recall. I do not see line rub but as these bikes get used/miles go on I guess it could start rubbing at any time. I may ask Pig Trail up there in Arkansas to check it out while on my ride. Got 3k on the bike and just put on my skid plate (glad I did....I can see hitting some tire debris and getting it slapped up on those exposed pipes). Sorry for the long comment....as for HD being junk because of the recall I was looking at a BMW R 18 and that was also recalled....so I guess a bike gets a recall and its junk per some of these comments.....The GW I was looking at got one as well....junk as well?

Would you recommend locktite on those bolts when putting it back together?

Is that default blue color for the Google Maps, so no regular white background? Night/Dark theme available?

I really like the Gerbing solution you found. I can use that cable plus the battery tender usb adapter to power my Maedhawk Bluetooth using the heated gear adapter as you have shown. I’m think I really should add a fuse in that line since it appears the Harley heated gear cord is not fused (I assume). I have Tourmaster heated gear and a fuse is part of the connection provided with the gear. I don’t see any fuse on the bike labeled for the heated gear cable. In fact, there doesn’t seem to be a whole lot of fuses on my 2024 Street Glide.

Additionally, the USB-C port indicates 100W, which should be for power output and supports fast charging, while the USB-A port is only for data transfer, and using it for charging would have little effect, just keeping the device from shutting down.

Why doesn't the Bluetooth receiver plug directly into the USB-A port, and instead use an additional USB-C to USB-A adapter?

Could you address my concerns? I would really appreciate it!

Nowadays, all phones use USB-C charging heads, so isn't it unnecessary to leave a USB-A port?

Hello my friend, I've watched all your videos one by one, and I have a question: Why doesn't the Bluetooth receiver plug directly into the USB-A port, but instead uses an additional USB-C to USB-A adapter?

Can you really call a pair of HD bag organizers at $120.00 "expensive", When you buy a CVO???😂

Best tutorial video in KZbin page Sir. Thank you for the concise info. I need some guidance here. I own a 2020 m8 softail m8 low rider s and the bike comes with usb female plug equipped from the factory. Which is nice but problem I have is that I have three devices attempted to charge while I am riding. One for one cell phone that I use on my cardo intercom for music I listen to, two, my other cell phone glfor gps, and third, my gopro camera mounted on my handlebar. Currently, I am using splitter with three heads. Works sometimes but not consistently working as I find time to time. Can you advise n give me some suggestions? Appreciate your feedback.

I immediately ordered an anti-skid plate on Amazon. The design without a hollow in the middle will definitely better prevent short circuits.

Does music still come out of the speakers?

Once you tricked it isn’t CarPlay also wireless too?

Is there a USB or USB-C connector under the seat that’s similar to the one in the front?

taking it to the dealer tomorrow , if there is no damage to the wire and the dealer straps it to the radiator hose , would you suggest still taking it back to the dealer to install the kit when its available next month or just leave it as is?

Question and somethings I possibly missed. I have the z6 box. Is it possible to set up the box for Android Auto on my RG. I can get that far, but where do i connect my actual headset? To my phone? Honestly I'm confused

Good job, as always.

My 17 roadking was routed where the wires running from the stator to regulator rubbed the engine case till it shorted out two regulators and eventually fried the stator before I figured it out. Rerouted it and zip tied it so it was ever going to be an issue again.

Another great video. I did install that Thrashin skid plate and highly recommend it. I will post a video of it soon. Ride safe.

thats not a wire wrapped around the wire it is solder wrapped around it . same with the ring it is a ring of solder

Another reason I am glad I did not get a 2024. These bikes have been other but problems. Every Moto vlogger on a 2024 has had horror stories about their new bikes.

Great information here ! Off topic, my 2024 street glide with skyline os has a very low navigation prompt both on cardo and speakers. If I use car play with Apple Maps the volume is nice and loud both headset and speakers. Dealer has no answers . Thanks

Question: Can you install and use the GoPro Quick app with this box? What a great way to setup a GoPro remote! It might have to be downloaded as an APK

Does this affect the 24 Road King Special?

Good stuff!

👍 I fixed this morning at the dealer

These new 24 model bikes are cheap built junk.

Did they put out a service bulletin for how not to be woke?

Thanks so much for this Video, after hearing about the last recall I still couldn’t figure it out. You make me job easer, keep doing what you’re doing.😊

I had a look at that area on my 2024 street glide. I didn’t see any issues. The second wire bundle you are pointing to on your bike that has been rubbing is actually routed differently on my bike. It’s run over the adjacent molded plug just above the wire you are referencing, so it isn’t at all close enough to rub. It will be interesting to see next week if the dealer finds any issue on my bike. My bike was made in February 2024 but I don’t know if my VIN is involved in the recall.

Your information is always useful! Love your channel. Thank you sir.

Thanks Bro! Very helpful.

Cheap ass Chinese harness.

Thanks again Tom, but if I run into this issue it's going to the dealer. That repair procedure is above my pay grade. 😂

This is great information. Thank you